(2)
 Headrest The headrest has a foam cushion which is covered with a fabric seat-cover.

 (3)
 Backrest The backrest has a foam cushion which is covered with a fabric seat-cover.

 (4)
 Seatpan The seatpan is made of a light alloy and has a foam cushion with a fabric seat-cover. The seat pan is spring loaded to return the seat to the retracted position when it is not in use.

 EFF : ALL

25-22-00Page 6
Aug 01/05
R
 CES

 Cabin Attendant Seat, Free Standing Figure 002
R  EFF : CES  ALL  25-22-00 Page 7 Aug 01/05 

 Cabin Attendant Seat, Wall Mounted Figure 003 
R  EFF :  ALL  25-22-00 Page 8 Aug 01/05
 CES 

 Cabin Attendant Seat, Swivel Figure 004
R  EFF : CES  ALL  25-22-00 Page 9 Aug 01/05 

 Double Cabin Attendant Seat, Wall-Mounted Figure 005 
R  EFF :  051-099, 151-199, 201-210,  25-22-00 Page 10 Aug 01/05
 CES 

 Restraint System Figure 006 
R  EFF :  ALL  25-22-00 Page 11 Aug 01/05
 CES 

 (5)
 Restraint System (Ref. Fig. 007) The restraint system is divided into a seat belt assy and a shoulder harness. Each cabin-attendant seat has a seat belt assy and a shoulder harness with a center buckle. The shoulder harness uses inertia reels to automatically pull it in when the seat is not in use. Static type shoulder harnesses are available as an option.

 (6)
 Stowage Compartment Each CAS has a stowage compartment which has a spring-loaded latch door. The stowage compartment can be used to stow emergency equipment.

 (7)
 Cabin Attendant Seat, Swivel (if installed)

 (a)
 To put the swivel seat in the sitting position from the stowed position:

 -swing the seatback (against the spring force) across the base until the seat aligns with the locking device,
 -push the seatpan down (against the spring force) into the locking device.

 (b)
 To put the swivel seat in the stowed position from the sitting position: - operate the release lever to the seatpan (when this is done the

 seatpan will automatically fold up),
 -move the seat over the base until the seat automatically locks in the stowed position.
 EFF : ALL

25-22-00Page 12
Aug 01/05
R
 CES

 INTENTIONALLY BLANK

 Restraint System
 Figure 007 (SHEET 1)
 EFF :  ALL  25-22-00 Page 14 
Aug 01/05
 CES 

 Restraint System
 Figure 007 (SHEET 2)
 EFF :  ALL  25-22-00 Page 15 
Aug 01/05
 CES 

 CABIN ATTENDANT SEATS - DEACTIVATION/REACTIVATION
_________________________________________________
 TASK 25-22-00-040-001 Deactivation of a Defective Cabin Attendant Seat
 1. Reason for the Job
__________________
 Refer to the MMEL TASK: 25-22-01
 Cabin Attendant Seats

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific 1 WARNING NOTICE
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
 Power 25-22-41-000-001 Removal of the Wall-Mounted Cabin-Attendant Seats 25-22-42-000-001 Removal of the Free-Standing Cabin-Attendant Seat(s) 25-22-43-000-001 Removal of the Cabin Attendant Swivel-Seat
 3. Job Set-up
__________ Subtask 25-22-00-861-052
 A. Energize the ground service network
 (Ref. TASK 24-42-00-861-001).

 EFF : ALL

25-22-00Page 401

 4. Procedure
_________ Subtask 25-22-00-040-050
 A. Deactivation of a Defective Cabin Attendant Seat
 (1)
 Safety the affected seat in its stowed position. NOTE : Put a WARNING NOTICE in position to tell persons not to use

____
 the seat.

 (2)
 If you cannot safety the seat, remove it:
 (Ref. TASK 25-22-41-000-001)
 or
 (Ref. TASK 25-22-42-000-001)
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備1(148)