(2)
Disengage the antenna (1) away from the bulkhead (4).
(3)
Remove and discard the O-rings (2).
(4)
Disconnect the coaxial connectors (3).
(5)
Remove the antenna (1).
(6)
Put blanking caps on the disconnected coaxial connectors (3) and (5).
1EFF : ALL 1 34-36-18Page 403 1 1 May 01/05R 1 1 1CES 1
Glide/Slope Antenna Figure 401/TASK 34-36-18-991-001
1EFF : 1 1R 1CES ALL 1 11 1 34-36-18 Page 404 May 01/05
TASK 34-36-18-400-001
Installation of the Glide/Slope Antenna (4RT)
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______
ONLY WITH A GOOD SUPPLY OF AIR.
OBEY THE MANUFACTURERS INSTRUCTIONS.
PUT ON PROTECTIVE CLOTHING.
DO NOT GET THEM IN YOUR MOUTH.
DO NOT SMOKE.
DO NOT BREATHE THE GAS.
THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
WARNING : DO NOT GET THE COMPOUND ON YOUR SKIN.
_______
IF YOU DO:
-RUB IT OFF IMMEDIATELY WITH A CLEAN CLOTH
-WASH THE SKIN WITH SOAP AND RINSE WITH CLEAN WATER.
R WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
_______ R - FLUSH IT AWAY WITH CLEAN WATER R - GET MEDICAL AID.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific lint-free cloth
No specific warning notice
No specific access platform 3.5 m (11 ft. 6 in.)
1EFF : ALL 1 34-36-18Page 405 1 1 May 01/05 1 1 1CES 1 B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 05-013 D TV-53-3507/73 RELEASE AGENT (OBSOLETE USE 05-013A) (Ref. 20-31-00)
Material No. 09-016 USA MIL-PRF-81733D TYPE II CLASS B CORROSION INHIBITING FILLET CONSISTENCY (Ref. 20-31-00)
Material No. 09-019 USA AMS 3267/3 LOW ADHESION CORROSION INHIBITING SEALANT (Ref. 20-31-00)
Material No. 11-003 USA ASTM D 740 METHYL-ETHYL-KETONE (Ref. 20-31-00)
C. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM --------- |DESIGNATION ---------------------------------------- |IPC-CSN------------------------------
2 O-rings 34-36-18 01 -010
D. Referenced Information
------------------REFERENCE -------------------------------DESIGNATION ------------------------------
-------------------------------------------------------------------------------
34-36-00-720-001 Functional Test of the ILS 34-36-00-720-002 Functional Test of the ILS 51-76-11-300-001 Repair of the Sealing 53-15-11-010-001 Opening of the Radome 110AL 53-15-11-410-001 Closing of the Radome 110AL 34-36-18-991-001 Fig. 401
3. Job Set-up
__________
Subtask 34-36-18-860-050
A. Aircraft Maintenance Configuration
(1) In the cockpit, make sure that the warning notice is in position on the center pedestal to tell persons not to operate or to start the weather radar system.
1EFF : ALL 1 34-36-18Page 406 1 1 May 01/05R 1 1 1CES 1
(2) Make sure that the access platform is in position below the radome in zone 110.
(3) Make sure that the radome 110AL is open (Ref. TASK 53-15-11-010-001).
Subtask 34-36-18-865-051
B. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R **ON A/C 001-004, 051-060,
49VU NAV/ILS/1 121VU COM NAV/ILS/2 1RT1 1RT2 G12K09
**ON A/C ALL
121VU COM NAV/RADAR/1 5SQ1 K13
R **ON A/C 051-099,
R 121VU COM NAV/RADAR/2 5SQ2 K14
R **ON A/C ALL
Subtask 34-36-18-160-050
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航3(21)
