MMR - System Test
Figure 025A
R 1EFF : 001-049, 101-149, 151-199, 201-299, 1 34-36-00Page 60 1301-399, 401-499, 1Config-2 Aug 01/05 1 1 1CES 1R **ON A/C ALL
(3) Reporting function The tables below give the list of internal/external failures.
(a) Internal failure:
-----------------------------------------------------------------------------I ATA I CLASS I MESSAGE I I I (A/C) I I I----------------------------------------------------------------------------I 34-36-31 I 1 I MMRi (40RTi) I I 34-36-11 I 1 I LOCALIZER ANTENNA (3RT)/COAX CABLE/MMRi(40RTi) I I 34-36-18 I 1 I GLIDE ANTENNA (4RT)/COAX CABLE/MMRi (40RTi) I I 34-36-16 I 1 I GPS ANTENNAi (43RTi)/COAX CABLE/MMRi(40RTi) I I I I i = (1,2) I -----------------------------------------------------------------------------
(b) External failure:
-----------------------------------------------------------------------------I ATA I CLASS I MESSAGE I I I (A/C) I I -----------------------------------------------------------------------------I 31-32-34 I 3 I CFDIU (1TW)/MMRi (40RTi) I I 22-83-34 I 3 I FMGCi (1CAi)/RMPi (1RGi)/MMRi (40RTi) I I 22-83-34 I 3 I FMGCj (1CAj) BUS ILS/MMRi (40RTi) I I 22-83-34 I 3 I FMGC1 (1CA1) BUS GPS/MMRi (40RTi) I I 22-83-34 I 3 I FMGC2 (1CA2) BUS GPS/MMRi (40RTi) I I 34-12-34 I 3 I ADIRUk (1FPk)/MMRi (40RTi) I I 32-31-71 I 3 I LGCIUi (5GAi)/FMGCi (1CAi)/MMRi (40RTi) I I 31-62-34 I 1 I DMCi (1WTi)/MMRi (40RTi) I I I I j,i = (1,2) or (2,1) I I I I k = 1, 2 or 3 I -----------------------------------------------------------------------------
1EFF : ALL 1 34-36-00Page 61
1 1 Config-2 May 01/05 1 1 1CES 1 **ON A/C 051-099,
(4) Interactive function To gain access to the BITE, it is necessary to use one MCDU (Ref. 22-82-00). (Ref. Fig. 017, 018, 019, 020, 021, 022, 023, 024, 025) All the information displayed on the MCDU during the BITE TEST configuration can be printed by the printer (Ref. 31-35-00).
R **ON A/C 001-049, 101-149, 151-199, 201-299, 301-399, 401-499,
(4) Interactive function To gain access to the BITE, it is necessary to use one MCDU (Ref. 22-82-00). (Ref. Fig. 017A, 018A, 020, 021, 022, 023, 024A, 025A) All the information displayed on the MCDU during the BITE TEST configuration can be printed by the printer (Ref. 31-35-00).
**ON A/C 051-099,
B. BITE Implementation
(1) Activation of the receiver face test The receiver face test can be activated by pushing the TEST pushbutton switch on the receiver face, if the test inhibit discrete is not active. The sequence below is then generated on the receiver face. Depending on the outcome of the receiver face test, one of the following results is displayed:
-----------------------------------------------------------------------------I SEQUENCE I LRU STATUS I CONTROL I ANT FAIL I I TIME I I NO. I LED (DS1) I FAIL LED I LED I DEFINITION I DEFINITION I I I I (DS2) I (DS3) I I I I---------------------------------------------------------------------------I I 1 I Red I Red I Red I LED self- I 2 seconds I I I I I I test I I I---------------------------------------------------------------------------I I 2 I Green I Red I Red I LED self- I 2 seconds I I I I I I test I I I---------------------------------------------------------------------------I I 3 I Off I Off I Off I Unit self- I 2 seconds I I I I I I test I minimum I I---------------------------------------------------------------------------I
1EFF : ALL 1 34-36-00Page 62 1 1 Config-2 Aug 01/05 1 1 1CES 1
-----------------------------------------------------------------------------
I SEQUENCE I LRU STATUS I CONTROL I ANT FAIL I I TIME I
I NO. I LED (DS1) I FAIL LED I LED I DEFINITION I DEFINITION I
I I I (DS2) I (DS3) I I I
I---------------------------------------------------------------------------I
R I 4 I Green I Off I Off I Unit passedI 30 seconds I
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址:A320飛機維護手冊 AMM NAVIGATION 導航3(3)