(3)
On the ADIRS CDU, set the OFF/NAV/ATT selector switch of the ADIRU1 and ADIRU3 to NAV to get the ND display.
(4)
On the panel 8VU, make sure that the ATT HDG selector switch is at NORM.
(5)
On the FCU, on the CAPT and F/O EFIS control sections :
-set the mode selector switches to ROSE NAV or ARC.
(6)
On the radar control unit, set :
-
the ON/OFF switch to OFF
-
the GAIN potentiometer to AUTO
-
the TILT selector switch to 0.
-
the mode selector switch to WX.
-the WINDSHEAR AUTO/OFF switch to OFF. R **ON A/C 051-099, 106-149, 201-299, 301-399, 401-499,
Subtask 34-41-00-860-050-D
C. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Do the EIS start procedure (EFIS only) (Ref. TASK 31-60-00-860-001).
1EFF : ALL 1 34-41-00Page 529 1 1 Aug 01/05 1 1 1CES 1
(3)
On the ADIRS CDU, set the OFF/NAV/ATT selector switch of the ADIRU1 and ADIRU3 to NAV to get the ND display.
(4)
On the panel 8VU, make sure that the ATT HDG selector switch is at NORM.
(5)
On the FCU, on the CAPT and F/O EFIS control sections :
-set the mode selector switches to ROSE NAV or ARC.
(6)
On the center pedestal, on the radar control unit, set :
-
the SYS 1/OFF/2 selector switch to OFF
-
the GAIN potentiometer to CAL
-
the TILT selector switch to 0.
-
the mode selector switch to WX
-
the GNR CLTR SPRS switch to OFF.
-
the PWS AUTO/OFF switch to OFF.
**ON A/C ALL
Subtask 34-41-00-865-054
D. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
-------------------------------------------------------------------------------
121VU COM NAV/RADAR/1 5SQ1 K13
R **ON A/C 051-099,
R 121VU COM NAV/RADAR/2 5SQ2 K14
1EFF : ALL 1 34-41-00Page 530 1 1 May 01/05 1 1 1CES 1
R **ON A/C ALL
R 4. Procedure_________ **ON A/C 001-049, 101-105, 151-199,
Subtask 34-41-00-730-050
A. Antenna Stabilization Test by the ADIRU 3 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the center pedestal, on the radar control unit :
-set the ON/OFF selector switch to ON.
2. On the panel 8VU :
-set the ATT HDG selector switch to CAPT 3.
3. On the ADIRS CDU :
-set the OFF/NAV/ATT selector switch of the ADIRU 1 to OFF.
4. On the ADIRS CDU :
-set the OFF/NAV/ATT selector switch of the ADIRU 3 to OFF.
5. On the center pedestal, on the radar control unit :
-set the ON/OFF selector switch to OFF.
The CAPT and F/O NDs show the radardisplay.
On the CAPT and F/O NDs, the radardisplay stays in view.
On the CAPT and F/O NDs, the radardisplay stays in view.
On the CAPT and F/O NDs :
-after some seconds, the WR ATTwarning indication is shown on the right.
-the radar display stays in view.
On the CAPT and F/O NDs :
-after some seconds, the radar displayand the WR ATT warning indication goout of view.
1EFF : ALL 1 34-41-00Page 531 1 1 May 01/05 1 1 1CES 1R **ON A/C 051-099,
R Subtask 34-41-00-730-050-D
R A. Antenna Stabilization Test by the ADIRU 3
R -------------------------------------------------------------------------------R ACTION RESULT R -------------------------------------------------------------------------------
R 1. On the center pedestal, on the
R radar control unit :
R - set the SYS 1/OFF/SYS 2
R selector switch to 1 (2).
R 2. On the panel 8VU :
R - set the ATT HDG selector switch
R to CAPT 3.
R 3. On the ADIRS CDU :
R - set the OFF/NAV/ATT selector
R switch of the ADIRU 1 to OFF.
R 4. On the ADIRS CDU :
R - set the OFF/NAV/ATT selector
R switch of the ADIRU 3 to OFF.
R
R
R 5. On the center pedestal, on the
R radar control unit :
R - set the SYS 1/OFF/SYS 2
R selector switch to OFF.
The CAPT and F/O NDs show the radar display.
On the CAPT and F/O NDs, the radar display stays in view.
On the CAPT and F/O NDs, the radar display stays in view.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航3(61)
