Subtask 52-71-00-010-069
 B. Get Access WARNING : DO NOT OPEN THE PASSENGER/CREW DOOR IF THE WIND SPEED IS MORE
_______
 THAN 65 KNOTS.

 WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
 -
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.

 -
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.

 WARNING : STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES.
_______ RESIDUAL PRESSURE COULD CAUSE THE DOOR TO OPEN WITH A SUDDEN FORCE AND INJURE PERSONS AND/OR DAMAGE THE AIRCRAFT.
 (1) Put the access platform in position at the applicable passenger/crew door 831 or 841 or 832 or 842.
 (a)
 Open the applicable passenger/crew door (Ref. TASK 52-10-00-010-001).

 (b)
 Obey the special precautions before you start work on the door (Ref. TASK 52-10-00-860-001).

 Subtask 52-71-00-865-075
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU EIS/SLIDES/ARM AND WARN/FLT 15WN P11 121VU EIS/SLIDES/ARM AND WARN/GND 13WN P10 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX 48WV P05
 Subtask 52-71-00-020-055
 D. Removal of the Door Lining Panels
 (1) Remove the lining panel.
 FOR 4WN1
 831CZ (Ref. TASK 25-23-46-000-001).

 1EFF : ALL 1 52-71-00Page 539 1 1 May 01/04R 1 1 1CES 1

 FOR 4WN2
 841CZ (Ref. TASK 25-23-46-000-001).

 FOR 7WN1
 832CZ (Ref. TASK 25-23-46-000-002).

 FOR 7WN2
 842CZ (Ref. TASK 25-23-46-000-002).

 FOR 13WV1
 831EZ, 831CZ (Ref. TASK 25-23-46-000-001).

 FOR 13WV2
 841EZ, 841CZ (Ref. TASK 25-23-46-000-001).

 FOR 17WV1
 832EZ, 832CZ (Ref. TASK 25-23-46-000-002).
 FOR 17WV2
 842EZ, 842CZ (Ref. TASK 25-23-46-000-002).

 4. Procedure
_________ Subtask 52-71-00-820-051
 A. Adjustment of the Proximity Switches (4WN1, 4WN2, 7WN1, 7WN2)
 (Ref. Fig. 505/TASK 52-71-00-991-003)

 WARNING : DO NOT OPEN THE DOOR DURING THE ADJUSTMENT.
_______
 (1)
 Make sure that all the doors are closed.

 (2)
 Remove the SAFETY PIN - SLIDE ARMING (98D52103500000).

 (3)
 Put the emergency control handle in the ARMED position.

 (4)
 Disconnect the electrical connector (8) of the proximity switch (1).

 (5)
 Put blanking caps on the disconnected electrical connectors.

 (6)
 Connect the CHECKING TOOL-DOORS (355M03210000) to the electrical connector (8) of the proximity switch (1).

 (7)
 Remove the nut (3) and the washer (4) or (5) or (6) or (7) and discard it.

 1EFF : ALL 1 52-71-00Page 540 1 1 May 01/04R 1 1 1CES 1

 Proximity Switches (4WN1, 4WN2, 7WN1, 7WN2, 13WV1, 13WV2, 17WV1, 17WV2) of the
 Passenger/Crew Doors
 Figure 505/TASK 52-71-00-991-003

 1EFF : ALL 1 52-71-00Page 541 1 1 May 01/04R 1 1 1CES 1

 (8)
 Turn the target (2) until the NEAR indicator light comes on. NOTE : The target (2) and the proximity switch (1) must not be in

____
 contact.

 (9)
 Turn the target (2) in the opposite direction until the FAR indicator light comes on.

 (10)
 From this position, screw the target (2) by two turns to two turns and a half.

 (11)
 Apply LUBRICANTS (Material No. 06-005) on the threads of the target (2).

 (12)
 Install a new washer:

 -
FOR 4WN1, 4WN2
 washer (4)

 -
FOR 7WN1, 7WN2
 washer (5)

 (13)
 Install the nut (3).

 (14)
 TORQUE the nut (3) to between 0.3 and 0.4 m.daN (26.54 and 35.39 lbf.in).

 (15)
 Safety the nut (3) with the washer (4) or (5) or (6) or (7).

 (16)
 Remove the blanking cap from the electrical connector (8).

 (17)
 Disconnect the CHECKING TOOL-DOORS (355M03210000) from the proximity switch (1).

 (18)
 Connect the electrical connector (8) of the proximity switch (1).

 (19)
 Put the emergency control handle in the DISARMED position.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門8(8)