(a) Engine suspected of experiencing excessive g loading during transportation must be given the following inspection. The inspection consists of visual and manual checks followed by a functional check.

 (2) Check engine for obvious damage as follows:

 (a) Visually inspect for buckling, deformation or cracking in engine skin and flange areas around transportation mounts.
 F 『 EEFF : ALL E Page 63772-00-00
 E E Aug 01/05 ERE
ECES E

 F  『
 E  C F M  E
 E  E

 E 56-5B E
 E E
 (b) To turn fan rotor by hand:

 WARNING : USE CARE TO AVOID PERSONAL INJURY WHEN YOU MANUALLY
_______ TURN THE FAN ROTOR. ASSURE SAFE FOOTING.USE HEAVY PROTECTIVE GLOVES
 1 Turn fan rotor by hand ; check for bearing roughness, unusual
_ noises and binding. Clear indications of this type of damage require engine disassembly.
 NOTE : Light rubbing of seals and shrouds is normal.
____
 (c) If seal or shroud interference is found and appears minimal, the engine can be considered serviceable after completing a successful dry motoring check (Ref. TASK 71-00-00-710-001) and power assurance check (Ref. TASK 71-00-00-710-008).

 (d) After functional test run, check scavenge screens and master magnetic chip detector for the presence of metal particles caused by bearing damage. Return engine to shop for inspection if unusual deposits are found.

 5. Close-up
________
 Subtask 72-00-00-410-075
 A. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.

 (2) Close the thrust reverser doors (Ref. TASK 78-36-00-410-040): FOR 1000EM1 451AL, 452AR FOR 1000EM2 461AL, 462AR

 Subtask 72-00-00-440-061
 B. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041).
 F 『 EEFF : ALL E Page 63872-00-00
 E E Aug 01/05 ERE
ECES E Subtask 72-00-00-410-080

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 C. Close Access
 (1) Close the fan cowl doors (Ref. TASK 71-13-00-410-040): FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR

 (2) Remove the warning notice(s).

 F 『 EEFF : ALL E Page 63972-00-00
 E E Aug 01/05 ERE
ECES E TASK 72-00-00-200-009 Off-Schedule Vane Replacement

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 1. Reason for the Job

__________________
 Self Explanatory

 2. Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 78-30-00-081-041 Make the Thrust Reverser Serviceable after
 Maintenance 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-36-00-010-040 Opening of the Thrust Reverser Doors 78-36-00-410-040 Closing of the Thrust Reverser Doors
 3. Job Set-up
__________ Subtask 72-00-00-941-070
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 F 『 EEFF : ALL E Page 64072-00-00
 E E Aug 01/05 ERE
ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 72-00-00-010-077
 B. Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 Subtask 72-00-00-040-062
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ENGINE 發(fā)動機 1(45)