F 『
E C F M E
E E
E 56-5B E
E E
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power 71-00-00-710-001 Dry Motoring Check 71-00-00-710-003 Engine Automatic Start 71-00-00-710-028 Engine Shutdown 71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 72-00-00-100-008 Engine Washing Requirements 72-00-00-991-304 Fig. 705
3. Job Set-up
__________
Subtask 72-00-00-941-065
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 72-00-00-010-072
B. Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
F 『 EEFF : ALL E Page 72272-00-00
E E May 01/05 ERE
ECES E 4. Procedure
F 『
E C F M E
E E
E 56-5B E
E E
_________ Subtask 72-00-00-110-057
A. Preparation of the Engine for Washing CAUTION : CORROSION PREVENTIVE ADDITIVE SHOULD BE USED. HOWEVER, IF NONE
_______ OF THE CORROSION PREVENTIVE PRODUCTS SPECIFIED IS AVAILABLE, THE ENGINE MUST RESUME REVENUE SERVICE OPERATION WITHIN 24 HOURS FOLLOWING THE POST WASH TEST.
(1) For engine washing requirements (Ref. TASK 72-00-00-100-008). NOTE : The disconnection of P25 line is only available for engines
____
equipped with PMUX option.
(2) Disconnect PS3 line and P25 line (if installed) from the Electronic Control Unit (ECU).
(3) Plug the open tubes and ports of the ECU.
(4) Prepare an anti-freeze mixture, if necessary, as defined in engine washing requirements (Ref. TASK 72-00-00-100-008).
Subtask 72-00-00-410-072
B. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
(2) Close the fan cowl doors (Ref. TASK 71-13-00-410-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
Subtask 72-00-00-861-051
C. Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
F 『 EEFF : ALL E Page 72372-00-00
E E May 01/05 ERE
ECES E Subtask 72-00-00-860-051
F 『
E C F M E
E E
E 56-5B E
E E
D. Aircraft Maintenance Configuration
(1) On the overhead control and indicating panel 25VU, make sure that the ON legend of the ANTI-ICE/ENG 1(2) pushbutton switch is off.
(2) On the AIR COND panel 30VU, make sure that the OFF legend of the ENG 1(2) BLEED pushbutton switch is on.
Subtask 72-00-00-110-058
E. Engine Washing CAUTION : DO NOT WASH ENGINE EXPOSED TO DRY CHEMICAL FIRE EXTINGUISHING
_______
AGENTS.
CAUTION : DO NOT WASH ENGINE UNLESS THE EGT IS BELOW 150 DEG.F (66 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM ENGINE 發動機 1(73)
