F 『 EEFF : ALL E Page 40972-63-00
E E Aug 01/05 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
12-13-79-610-003 Oil Tank Draining 24-21-51-000-040 Removal of the Integrated Drive Generator -IDG 1(2),(4000XU) 26-12-15-000-042 Removal of the Fan Fire Detectors (4000WD1,4000WD2)
R 29-11-51-000-041 Removal of the Green Engine Pump (1030GK) 71-13-00-010-040 Opening of the Fan Cowl Doors 71-71-43-000-041 Removal of the Drain Manifold Module 71-73-49-000-003 Removal of the Starter Pad Oil Drain Tube 71-73-49-000-004 Removal of the IDG Oil Drain Tube 71-73-49-000-007 Removal of the Fan Case Drain Tubes 71-73-49-000-008 Removal of the Fuel Pump Drain Tubes 71-73-49-000-026 Removal of the Heat Exchanger Drain Tube 71-73-49-000-027 Removal of the Hydro Mechanical Unit (HMU) Drain Tube 71-73-49-000-028 Removal of the Hydraulic Pump Drain Tube 71-73-49-000-029 Removal of the Forward Oil Sump Drain Tube 71-73-49-000-049 Removal of the Reservoir to Manifold Hydraulic Oil
Drain Tube 72-63-00-860-001 Disengagement/Engagement of the Horizontal Drive
Shaft
73-11-10-000-003 Removal of the Fuel Pump and Filter Assembly
73-21-30-000-001 Removal of the Control Alternator
77-11-20-000-002 Removal of the N2 Speed Sensor (4001EV).
78-30-00-481-041 Make the Thrust Reverser Unserviceable for
Maintenance
78-36-00-010-040 Opening of the Thrust Reverser Doors
79-21-10-000-004 Removal of the Lubrication Unit
80-11-10-000-002 Removal of the Pneumatic Starter
72-63-00-991-309 Fig. 403
72-63-00-991-310 Fig. 404
72-63-00-991-311 Fig. 405
72-63-00-991-312 Fig. 406
72-63-00-991-313 Fig. 407
72-63-00-991-314 Fig. 408
F 『 EEFF : ALL E Page 41072-63-00
E E Aug 01/03 E E ECES E 3. Job Set-up
F 『
E C F M E
E E
E 56-5B E
E E
__________ Subtask 72-63-00-941-061
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 72-63-00-010-071
B. Get Access
(1) Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2) Put the access platform in position. Subtask 72-63-00-040-053
C. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). Subtask 72-63-00-010-074
D. Open the thrust reverser doors: (Ref. TASK 78-36-00-010-040)
FOR 1000EM1
451AL, 452AR
FOR 1000EM2
461AL, 462AR
F 『 EEFF : ALL E Page 41172-63-00
E E Aug 01/00 ERE
ECES E E 56-5B E
F 『
E C F M E
E E
E E
4. Procedure_________
(Ref. Fig. 403/TASK 72-63-00-991-309, 404/TASK 72-63-00-991-310, 405/TASK 72-63-00-991-311, 406/TASK 72-63-00-991-312, 407/TASK 72-63-00-991-313, 408/TASK 72-63-00-991-314)
Subtask 72-63-00-941-062
A. Put a container under the Accessory Gearbox to collect the remaining fluid from the tubes and control.
Subtask 72-63-00-010-070
B. Preparation for the Removal of the AGB CAUTION : USE 2 WRENCHES TO REMOVE OR INSTALL THE TUBE COUPLING NUTS.
_______ ONE WRENCH TO HOLD THE UNION AND ONE TO LOOSEN OR TIGHTEN THE COUPLING NUT. THIS WILL PREVENT DAMAGE TO THE HARDWARE.
(1) Remove the fan fire detector (Ref. TASK 26-12-15-000-042).
(2) Remove the drain manifold module (Ref. TASK 71-71-43-000-041).
(3) Remove the drain tubes under the AGB/TGB as follows: 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM ENGINE 發動機 2(135)
