F 『 EEFF : ALL E Page 45372-63-00
 E E May 01/05 ERE
ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
 - forward sump drain tube (Ref. TASK 71-73-49-400-029)

 (13) Install the drain manifold module (Ref. TASK 71-71-43-400-041).
 (14) Install the fan fire detector (Ref. TASK 26-12-15-400-042). Subtask 72-63-00-410-068

 E. Close Access
 (1) Make sure that the work area is clean and clear of tool(s) and other items.

 (2) Close the thrust reverser doors: (Ref. TASK 78-36-00-410-040) FOR 1000EM1 451AL, 452AR FOR 1000EM2 461AL, 462AR

 (3) Remove the warning notice(s). Subtask 72-63-00-440-051

 F. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041) Subtask 72-63-00-710-056

 G. Test after the Installation
 (1) Do a minimum idle check (Ref. TASK 71-00-00-710-006) and a check for leaks (Ref. TASK 79-00-00-210-003).

 (2) Do a check of the oil level (Ref. TASK 12-13-79-610-002) or (Ref. TASK 12-13-79-610-002).

 (3) Do an accel check (Ref. TASK 71-00-00-710-025).

 F 『 EEFF : ALL E Page 45472-63-00
 E E May 01/05 ERE
ECES E 5. Close-up

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

________ Subtask 72-63-00-410-069
 A. Close Access
 (1) Close the fan cowl doors: (Ref. TASK 71-13-00-410-040) FOR 1000EM1 437AL, 438AR FOR 1000EM2 447AL, 448AR

 (2) Remove the access platform(s).

 F 『 EEFF : ALL E Page 45572-63-00
 E E May 01/05 E E ECES E

 F  『
 E  C F M  E
 E  E

 E 56-5B E
 E E
 ACCESSORY GEARBOX ASSEMBLY - INSPECTION/CHECK

_____________________________________________ TASK 72-63-00-210-002 Inspection/Check of the Accessory Gearbox Assembly
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific  warning notice
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No.  CP8001 * lockwire 0.032 in. (0.8 mm) dia. (Ref. 70-30-00) Material No. CP8002 * lockwire 0.032 in. (0.8 mm) dia. (Ref. 70-30-00)
 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors 71-13-00-410-040 Closing of the Fan Cowl Doors 72-63-00-300-002 Replacement of a Sealol Seal (Typical) 72-63-00-300-003 Replacement of a Magnetic Seal (Typical)
 F 『 EEFF : ALL E Page 60172-63-00
 E E Feb 01/98 E E ECES E 3. Job Set-up

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

__________ Subtask 72-63-00-941-057
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 72-63-00-010-064
 B. Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 4. Procedure
_________ Subtask 72-63-00-210-052
 A. Inspection of the AGB external areas.
 -------------------------------------------------------------------------------INSPECT/CHECK MAXIMUM REMARKS SERVICEABLE LIMITS -------------------------------------------------------------------------------
1. Housing for :
 A. Cracks  Not serviceable
 B. Nicks, dents and Any number, 0.035 in.
 scratches  (0.9 mm) deep after
 removal of high metal.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ENGINE 發動機 2(146)