- ADIRU-2 (1FP2)

 - wiring from the MMR1 to the ADIRU2

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
AMM 34-12-34-000-001 Removal of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-12-34-400-001 Installation of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-14-00-740-001 Interface Test of the IR
 AMM 34-36-31-000-002 Removal of the Multi Mode Receiver (40RT1, 40RT2)
 AMM 34-36-31-400-002 Installation of the Multi Mode Receiver (40RT1,

 40RT2)
 ASM 34-36/02

 3. Fault Confirmation
__________________
 A. Test
 (1) Do the Interface test of the IR (system 2) (Ref. AMM TASK 34-14-00-740-001).
 4. Fault Isolation
_______________
 A. If the test gives the maintenance message MMR1-GPSSU1(40RT1-1SN1)/ ADIRU2(1FP2):
 NOTE : In this case the GPSSU1 message is for the GPS part of the MMR1.
____
 - replace the MMR-1 (40RT1) (Ref. AMM TASK 34-36-31-000-002) and (Ref. AMM TASK 34-36-31-400-002).
 (1) If the fault continues:
 - replace the ADIRU-2 (1FP2) (Ref. AMM TASK 34-12-34-000-001) and (Ref. AMM TASK 34-12-34-400-001).
 (a) If the fault continues:
 - do a check and repair the wiring from the MMR1 to the ADIRU2: pins AB/2J, 2K to pins AB/7C, 8C for the GNSS INPUT 2 DATA bus and pins AB/2G, 2H to pins AB/1C, 2C for the GNSS INPUT 2 TIME MARK bus (Ref. ASM 34-36/02).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page A248
 May 01/05R CES

 B. Do the test given in para. 3.

 Loss of the MMR1 data on the ADIRU3
 1. Possible Causes
_______________
 - MMR-1 (40RT1)

 - ADIRU-3 (1FP3)

 - wiring from the MMR1 to the ADIRU3

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-12-34-000-001 Removal of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-12-34-400-001 Installation of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-14-00-740-001 Interface Test of the IR
 AMM 34-36-31-000-002 Removal of the Multi Mode Receiver (40RT1, 40RT2)
 AMM 34-36-31-400-002 Installation of the Multi Mode Receiver (40RT1,

 40RT2)
 ASM 34-36/02

 3. Fault Confirmation
__________________
 A. Test
 (1) Do the Interface test of the IR (system 3) (Ref. AMM TASK 34-14-00-740-001).
 4. Fault Isolation
_______________
 A. If the test gives the maintenance message MMR1-GPSSU1(40RT1-1SN1)/ ADIRU3(1FP3):
 NOTE : In this case the GPSSU1 message is for the GPS part of the MMR1.
____
 - replace the MMR-1 (40RT1) (Ref. AMM TASK 34-36-31-000-002) and (Ref. AMM TASK 34-36-31-400-002).
 (1) If the fault continues:
 - replace the ADIRU-3 (1FP3) (Ref. AMM TASK 34-12-34-000-001) and (Ref. AMM TASK 34-12-34-400-001).
 (a) If the fault continues:
 - do a check and repair the wiring from the MMR1 to the ADIRU3: pins AB/9E, 9F to pins AB/14D, 15D for the GNSS INPUT 3 DATA bus and pins AB/7E, 7F to pins AB/14J, 15J for the GNSS INPUT 3 TIME MARK bus (Ref. ASM 34-36/02).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-36-00∞∞∞∞∞∞∞∞∞∞Page A250
 May 01/05 CES

 B. Do the test given in para. 3.

 Loss of the MMR2 data on the ADIRU3
 1. Possible Causes
_______________
 - MMR-2 (40RT2)

 - ADIRU-3 (1FP3)

 - wiring from the MMR2 to the ADIRU3

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-12-34-000-001 Removal of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-12-34-400-001 Installation of the ADIRU (1FP1, 1FP2, 1FP3)
 AMM 34-14-00-740-001 Interface Test of the IR
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 2(143)