1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
34-13-00-810-849 Loss of the ADR 1 BUS 2 Output Identified by the EFCS 2 34-13-81-810-823 Runaway or Drift of One ADR1 Parameter Identified by the ELACs and the SECs AMM 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning)
3. Fault Confirmation
__________________
A. Test
(1) Do the BITE test of the EFCS (Ground Scanning) (system 2) (Ref. AMM TASK 27-96-00-740-001).
4. Fault Isolation
_______________
A. If the test gives the maintenance message ADR1:
- read the Post Flight Report (PFR) for the maintenance messages related to the link between SEC and ADR.
(1) If the PFR gives the maintenance messages SEC1 OR BUS3 FROM ADR3 and/or SEC2 OR BUS2 FROM ADR2:
- do this trouble shooting procedure: (Ref. TASK 34-13-81-810-823).
(2) If the PFR does not give the above maintenance message:
- do this trouble shooting procedure: (Ref. TASK 34-13-00-810-849).
R (a) If the test gives a maintenance message related to the air data R system 1, do the trouble shooting procedure related to the R maintenance message.
B. Do the test given in Para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-13-81∞∞∞∞∞∞∞∞∞∞Page 215
May 01/05 CES Loss of the ADR3 Data Idenfified by the EFCS2
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
34-13-00-810-868 Loss of the ADR 3 BUS 2 Output Identified by the EFCS 2 34-13-81-810-825 Runaway or Drift of One ADR3 Parameter Identified by the ELACs and the SECs AMM 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning)
3. Fault Confirmation
__________________
A. Test
(1) Do the BITE test of the EFCS (Ground Scanning) (system 2) (Ref. AMM TASK 27-96-00-740-001).
4. Fault Isolation
_______________
A. If the test gives the maintenance message ADR3:
- read the Post Flight Report (PFR) for the maintenance messages related to the link between SEC and ADR.
(1) If the PFR gives the maintenance messages SEC1 OR BUS3 FROM ADR1 and/or SEC3 OR BUS2 FROM ADR2:
- do this trouble shooting procedure (Ref. TASK 34-13-81-810-825).
(2) If the PFR does not give the above maintenance message:
- do this trouble shooting procedure (Ref. TASK 34-13-00-810-868).
R (a) If the test gives a maintenance message related to the air data R system 3, do the trouble shooting procedure related to the R maintenance message.
B. Do the test given in Para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞34-13-81∞∞∞∞∞∞∞∞∞∞Page 216
May 01/05 CES
R **ON A/C 051-099, 106-149, 204-299, 301-399, 401-499,
TASK 34-13-81-810-816 Loss of the TAT Sensor 1 Input on the ADR1 and ADR3
1. Possible Causes
_______________
- SENSOR-TAT, 1 (11FP1)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 34-11-18-000-001 Removal of the TAT Sensor (11FP1, 11FP2) AMM 34-11-18-400-001 Installation of the TAT Sensor (11FP1, 11FP2)
3. Fault Confirmation
__________________
A. Test
(1) Not applicable, you cannot confirm this fault on the ground.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 導航 NAVIGATION 2(16)
