「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 101-105, 107-107, 151-199, ∞∞49-00-81∞∞∞∞∞∞∞∞∞∞Page B247
201-210, Config-1 Aug 01/05 CES -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R AMM 49-81-00-200-008 Detailed Visual Inspection of the Exhaust V-Clamp and R Portion of Exhaust Duct inside APU Compartment R (131-9(A))
3. Fault Confirmation
__________________
A. Do the operational test of the APU (Ref. AMM TASK 49-00-00-710-010) and do a check on the APU exhaust for oil smoke.
4. Fault Isolation
_______________
A. If there is oil smoke at the exhaust during the operation of the APU: R - disconnect the exhaust muffler from the APU exhaust duct as per Para. R 4.A. of AMM TASK (Ref. AMM TASK 49-81-00-200-008). R - do an inspection of the exhaust cone via the APU exhaust duct for oil R leakage.
R (1) If there is oil at the exhaust:
R - replace the APU AUXILIARY POWER UNIT (4005KM) (Ref. AMM TASK 49-11-R 11-000-004) and (Ref. AMM TASK 49-11-11-400-004).
R (2) If there is no oil at the exhaust:
- replace the Air/Oil Seperator Adapter (Ref. AMM TASK 49-26-54-000-
003) and (Ref. AMM TASK 49-26-54-400-001). R - do the cleaning and testing as given in the Para. 4.B. R
R (a) If the fault continues:
- replace the APU AUXILIARY POWER UNIT (4005KM) (Ref. AMM TASK 49-11-11-000-004) and (Ref. AMM TASK 49-11-11-400-004).
B. Cleaning and Testing
NOTE : If an external leak was identified on the APU:
____
- do the repair,
- clean the area,
- start and operate the APU with no bleed air supply and no APU generator load (Ref. AMM TASK 49-00-00-860-008),
- let the APU operate 15 minutes for thermal stabilization,
- do a leak check on the APU with a black light lamp,
- do the APU shutdown (Ref. AMM TASK 49-00-00-860-009),
- immediately after the APU has stopped, examine the area carefully and make sure that there is no leak,
- if there is a leak (the repair was not succesful), do the repair and/or replace as necessary.
- if there is no leak (the repair was successful), continue as given subsequent.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1R EFF : 001-049, 101-105, 107-107, 151-199, ∞∞49-00-81∞∞∞∞∞∞∞∞∞∞Page B248
201-210, Config-1 Aug 01/05 CES If no external leak was identified on the APU, do the procedure as given subsequent.
(1) If dirty, clean the APU compartment (Ref. AMM TASK 49-00-00-100-003).
(2) If dirty, clean the air intake diverter, the air inlet duct and the air intake diffuser and elbow (Ref. AMM TASK 49-16-00-100-003).
(3) Do a check and make sure that the flexible seals on the air intake system are in correct condition (Ref. AMM TASK 49-16-00-200-002) and clean.
(4) Do the cleaning of the APU compressors (Ref. AMM TASK 49-20-00-100-004).
(5) Clean the APU bleed air duct, the pneumatic ducts of the aircraft and the environmental control system (Ref. AMM TASK 21-00-00-615-001) or (Ref. AMM TASK 21-00-00-615-002) and (Ref. AMM TASK 21-00-00-100-001). 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 機載輔助動力 2(128)
