S 963-015-001

 (9)  
Replace the two O-rings that were below the self-closing valve and the tank drain plug.

 S 433-016-001

 (10)
 Install the self-closing valve (with the magnetic plug) into the CSD.

 (a)  
Tighten the plug to a torque of 30-40 pound-inches.

 (b)  
Install a lockwire.

 S 433-017-001
 (11) Install the tank drain plug into the CSD.
 (a)  
Tighten the plug to a torque of 75-100 pound-inches.

 (b)  
Install a lockwire.

 S 163-018-001
 CAUTION: IMMEDIATELY REMOVE ALL OF THE OIL THAT FALLS ON THE ENGINE.
_______ THE OIL CAN CAUSE DAMAGE TO THE PAINT AND THE RUBBER COMPONENTS ON THE ENGINE.
 (12) Clean the engine parts that have oil on them.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. CONSTANT SPEED DRIVES ú

 12-13-21
 ú CONFIG ú 02 Page 304 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 613-019-001
 (13) Add oil to the CSD before you operate the engine again.
 TASK 12-13-21-613-020-001
 4. Fill the CSD with Oil (Fig. 301)
_____________________
 A. General
 (1)  
The CSD sight glass has different ranges for the oil level on the left and right engines. This is because the left and right engines are at different angles.

 (2)  
The oil level shown on the sight glass of a disconnected CSD can show more oil than there is. Expanded air can push the oil from the oil cooler into the CSD. To get an accurate indication of the oil level, fill the CSD and look at the sight glass again.

 (3)  
Leakage of the seal in the CSD will let oil flow from the CSD to the spline cavity. A defective input shaft seal will cause these indications:

 (a)  
The oil level in the CSD will decrease.

 (b)  
The oil level in the spline cavity will increase.

 B. Special Tools and Equipment
 (1)  
Service Cart - Malabar 53361-2, Malabar Hydraulics Co., 220 West Los Angeles Avenue, Simi Valley, CA 93065

 (2)  
Coupling - OMP2506-3, Ozone Metal Products, 101-32 101st Street, Ozone Park, Long Island, NY 11416

 C. Consumable Materials
 (1)  D00068 Oil - MIL-L-23699, MIL-L-7808, or any oil that agrees with the specifications of CFM56-3 SB79-001.
 NOTE: Refer to the marker on the CSD to find the oil that is in the
____
 CSD.

 D. Reference
 (1)  AMM 71-11-02/201, Fan Cowl Panels
 E. Access
 (1)  Location Zones
 506 Engine 1 - Accessory Gearbox, 8 o'clock
 606 Engine 2 - Accessory Gearbox, 8 o'clock

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. CONSTANT SPEED DRIVES ú

 12-13-21
 ú CONFIG ú 01 Page 305 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (2)  Access Panels
 5746L Left Fan Cowl - Engine 1
 5737L Left Fan Cowl - Engine 2

 F. Add Oil to the CSD
 S 283-021-001
 CAUTION:_______PUT ONLY APPROVED OILS INTO THE GENERATOR DRIVE. OILS THAT ARE NOT APPROVED CAN CAUSE DAMAGE TO THE GENERATOR DRIVE.
 DO NOT MIX DIFFERENT TYPES OR BRAND NAMES OF OILS. SOME OILS WILL CHEMICALLY CHANGE WHEN YOU MIX THEM. THIS CAN CAUSE DAMAGE TO THE GENERATOR DRIVE.
 DO NOT LET ALKALINE CLEANING FLUIDS OR HYDRAULIC FLUID TOUCH THE GENERATOR DRIVE OIL. VERY SMALL QUANTITIES OF THESE FLUIDS CAN CAUSE THE OIL TO CHEMICALLY CHANGE. THIS CAN CAUSE DAMAGE TO THE GENERATOR DRIVE.
 (1) Make sure that you have the correct oil for the CSD.
 NOTE: If you put an oil that is not approved into the CSD,
____ drain the oil. Then flush the CSD oil system with an approved oil.
 To change between approved types of oil, drain all of the
 remaining oil before you add the new oil.
 S 033-022-001
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 SERVICING(37)