(b)
If it is necessary, inflate or deflate the strut to shift the point into the chart band.
S 783-003
(2) Measure the pressure and the extension of the strut with a load on the airplane (the usual dispatch weight).
NOTE: The weight of the airplane must be different from the
____ previous step by a minimum of 30,000 pounds. The ambient temperatures at time of measurements are taken should be within 20°F when you do this step.
(a) Compare the second pressure and extension with the servicing band on the servicing chart:
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-15-31
ALL ú ú 03 Page 319 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
(b) If the point falls on the servicing band, the fluid level is in the correct operating range. 1) If the point falls to the left of the servicing band, the
fluid level is low.
a) Add fluid (refer to paragraphs 2 or 3).
b) If it is necessary to add one quart or more to fill the
strut, find the source of the leakage and repair it. 2) If the point falls to right of the servicing band, fluid level is high.
NOTE: Too much (high) fluid level is caused by a prior
____
incorrect servicing procedure.
a) Remove the fluid (refer to paragraph 2 or 3).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
12-15-31
ALL ú ú 03 Page 320 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
NOSE LANDING GEAR SHOCK STRUT - SERVICING
_________________________________________
1. General
_______
A. This procedure contains two tasks. The first task does the servicing of the shock strut for the nose landing gear. The second task does a check of the fluid level for the shock strut of the nose landing gear.
TASK 12-15-41-603-001
2. Nose Landing Gear Shock Strut Servicing (Fig. 301)
_______________________________________
A. General
(1) This task changes the hydraulic fluid in the nose gear shock strut. This task also gives you the option to service the shock strut with the airplane lifted on jacks.
B. References
(1)
AMM 32-00-01/201, Ground Lock Assemblies
(2)
AMM 09-10-00/201, Towing
(3)
AMM 07-11-21/201, Jack Airplane Nose
C. Equipment
(1)
Low pressure servicing cart for MIL-H-5606, MIL-H-6083 hydraulic fluid or fully formulated shock strut fluid (AMM 20-30-21/201)
(2)
Strut inflation tool - F70200-1
(3)
Hose to suit air valve
(4)
Suitable container to collect hydraulic fluid (approximately 5-gallon capacity)
(5)
Drain Valve, Shock Strut - A32066-1
D. Consumable Materials
(1)
Dry air or nitrogen bottle charged to 2500 psi
(2)
Lubricant - (AMM 20-30-21/201)
(a) Shock Strut Extreme Pressure Additive - Lubrizol 1395
E. Prepare to Do the Servicing of the Shock Strut
S 483-026
WARNING: MAKE SURE THE GROUND LOCK PINS ARE INSTALLED ON ALL THE LANDING
_______ GEAR. WITHOUT THE GROUND LOCK PINS, THE LANDING COULD RETRACT AND CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(1) If the groundlock pins are not installed on all the landing gear, do this task: Install the ground lock assemblies (AMM 32-00-01/201).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 SERVICING(72)
