position when the AOA sensor is at +5.1 |0.5° + aerodynamic offset.
 NOTE: The slats take 5.0 |1 seconds (system B electric
____ motor driven pump only, system A off) or 3.5 |1.0 seconds (ground cart only, system A off) to move from the full extend to the (intermediate) extend position.
 2)  Make sure that as the slats start to retract, the SLATS 1 thru 6 FULL EXT lights go off and the SLATS 1 thru 6 TRANSIT lights come on.
 3)  Make sure that when the slats are at the (intermediate) extend position, the SLATS 1 thru 6 TRANSIT lights go off and the SLATS 1 thru 6 EXT lights come on.
 (g)  
Release the GROUND SENSING, AIR SENSING, and NOSE SENSING test switches.

 (h)  
Slowly turn the left AOA sensor clockwise 1.0 |0.5° from its present position.

 (i)  
Push and hold the GROUND SENSING test switch.

 1)  Make sure that the AUTO EXT light on ASC 1 comes on for approximately 0.5 to 2.5 seconds.

 (j)  
Release the GROUND SENSING test switch.

 (k)  
Turn the left AOA sensor clockwise to -25 |5°.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH AUTOSLAT ú

 27-83-00
 COMPUTER P/N 65-52818  ú CONFIG 1 ú 02 Page 509 ú Mar 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (l)  
Push and hold the GROUND SENSING, AIR SENSING, and NOSE SENSING test switches.

 (m)  
Slowly turn the right AOA sensor clockwise.

 1)  Make sure that the slats move to the full extend position when the AOA sensor is at +5.8 |0.5° - aerodynamic offset.
 NOTE: The slats take 3 |1 seconds to move from the
____ (intermediate) extend position to the full extend position.
 2)  Make sure that the AUTO EXT light on ASC 2 is on and the
 AUTO EXT light on ASC 1 is off. 3) Make sure that the PWR OK light on ASC 2 is on. 4) Make sure that the LE FLAPS EXT is on.
 (n)  
Push the master caution RECALL button.
 1) Make sure that the AUTOSLAT FAIL light is off.

 (o)  
Slowly turn the right AOA sensor counterclockwise until the AUTO EXT light on ASC 2 goes off. 1) Make sure that the slats move to the (intermediate) extend

 position when the AOA sensor is at +5.1 |0.5° - aerodynamic offset.
 NOTE: The slats take 5.0 |1 seconds (system B electric
____ motor driven pump only, system A off) or 3.5 |1.0 seconds (ground cart only, system A off) to move from the full extend to the (intermediate) extend position.
 2)  Make sure that as the slats start to retract, the SLATS 1 thru 6 FULL EXT lights go off and the SLATS 1 thru 6 TRANSIT lights come on.
 3)  Make sure that when then slats are at the (intermediate) extend position, the SLATS 1 thru 6 TRANSIT lights go off and the SLATS 1 thru 6 EXT lights come on.
 (p)  
Release the GROUND SENSING, AIR SENSING, and NOSE SENSING test switches.

 (q)  
Slowly turn the right AOA sensor counterclockwise 1.0 |0.5° from its present position.

 (r)  
Push and hold the GROUND SENSING test switch.

 1)  Make sure that the AUTO EXT light on ASC 2 comes on for approximately 0.5 to 2.5 seconds.

 (s)  
Release the GROUND SENSING test switch.

 (t)  
Turn the right AOA sensor counterclockwise to -25 |5°.

 (u)  
Push the master caution RESET button.

 S 865-026-001
 (4)  
Prepare for the test of the autoslat dynamic-alpha-compare mode:

 (a)  
Move the No. 1 and No. 2 thrust levers to the aft stop.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH AUTOSLAT ú

 27-83-00
 COMPUTER P/N 65-52818  ú CONFIG 1 ú 02 Page 510 ú Mar 15/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (b)  
Make sure that the ANTISKID switch on the P2 panel is in the ON position.

 (c)  
Set the selector switch on the antiskid control unit (in the electronic compartment) to LO.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 6(122)