C.
Access

 (1)  
Location Zone 101 Control Cabin, LH 102 Control Cabin, RH 302 Wing Outboard Leading Edge with Slats, LH 402 Wing Outboard Leading Edge with Slats, RH

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-81-51
 ALL  ú ú 01 Page 403 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (2)  
Access Panels
 6246 Slat Access Panel, LH
 6253 Slat Access Panel, LH
 6261 Slat Access Panel, LH
 6546 Slat Access Panel, RH
 6553 Slat Access Panel, RH
 6561 Slat Access Panel, RH

 D.  
Procedure

 S 424-009
 (1)  
Install the seal door:

 (a)  
Install the torsion springs. 1) Install the bolt, tube, spacer, spring, washer and nut. 2) Tighten the nut with your fingers. 3) Install the cotter pin.

 (b)  
Move the seal door in the seal guide and spacer.

 (c)  
Put the straps through the channel and on the seal door.

 CAUTION:_______BEND THE TORSION SPRINGS CAREFULLY. YOU CAN DAMAGE THE TORSION SPRINGS.

 (d)  
Install each spring through the hole in the seal door.

 (e)  
Make sure there is a 0.10 inch minimum overlap between the top of the skin cutout and the top edge of the seal door.

 NOTE: The seal doors must move freely.
____
 1)  If it is necessary, put the seal door straps in the adjustment slots to get a 0.10 inch minimum overlap.
 E.  Put the Airplane Back to Its Usual Condition
 S 414-010
 (1)  Install the access panels.
 S 084-011
 WARNING: CAREFULLY REMOVE THE LEADING EDGE SLAT ACTUATOR LOCKOUT SET.
_______ THE LEADING EDGE SLATS CAN MOVE QUICKLY IF YOU DO NOT REMOVE THE LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Remove the leading edge slat actuator lockout set from the actuators of the leading edge slats (Ref 27-81-00/201).

 (3)  
Pressurize hydraulic system B (Ref 27-81-00/201).

 S 864-013

 (4)  
Put the flap control lever to the FLAP UP detent to retract the flaps and slats.

 S 864-012
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-81-51
 ALL  ú ú 01 Page 404 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 864-014
 (5)  Release pressure from hydraulic system B (Ref 27-81-00/201).
 TASK 27-81-51-004-015
 4.  Thermal Anti-Icing Duct Seal Door Removal_________________________________________
 A. Special Tools and Equipment
 (1)  
C27012-1 - Leading Edge Slat Actuator Lockout Set

 B.
References

 (1)
27-81-00/201, Leading Edge Flap and Slat Control System

 C.
Access

 (1)  
Location Zone 101 Control Cabin, LH 102 Control Cabin, RH 302 Wing Outboard Leading Edge with Slats, LH 402 Wing Outboard Leading Edge with Slats, RH

 (2)  
Access Panels
 6247 Slat Access Panel, LH
 6254 Slat Access Panel, LH
 6262 Slat Access Panel, LH
 6547 Slat Access Panel, RH
 6554 Slat Access Panel, RH
 6562 Slat Access Panel, RH

 D.
Prepare for Removal

 (1)  
Pressurize hydraulic system B (Ref 27-81-00/201).

 S 864-017

 (2)  
Put the flap control lever to the 10-unit detent to extend the slats.

 (3)  
Release pressure from hydraulic system B (Ref 27-81-00/201).

 S 864-016
 S 864-018
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-81-51
 ALL  ú ú 01 Page 405 ú Nov 15/91
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 6(92)