TASK 31-24-00-735-011
 3.  System Test - Flight Data Recorder System_________________________________________
 A. General
 (1)  
The system test has procedures to do tests of all the inputs to the flight data recorder system. You can do the tests out of sequence. You can do each test independently.

 (2)  
To do the system test, much time can be necessary. A different procedure, which makes sure the system writes the parameters correctly, is the copy recorder procedure (AMM 31-24-00/201).

 (3)  
The tests in this procedure are written to the BOEING standard application software. If customized software is installed part of the test may not look the same. Installation of the BOEING application software may be necessary.

 (4)  
These tasks use the word SUBFRAME 0 to make a selection of a parameter which is on all four subframes. Some portable testers do not have a switch position for SUBFRAME 0. On these test sets, make a selection of subframes 1 thru 4 when the task uses SUBFRAME 0.

 B. Access
 (1)  Location Zone
 101 Control Cabin - Left
 102 Control Cabin - Right

 C. Procedure
 S 865-012
 (1)  
Do this task: "Prepare for the Input Parameters Test."

 (2)  
Do this task: "Event Marker Signals Test."

 S 735-013
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. B-2531 AND B-2532 ú
 31-24-00
 ú ú 09 Page 502 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 735-014
 (3)  
Do this task: "Magnetic Heading Signals Test."

 S 735-015

 (4)  
Do this task: "Acceleration Signals Test."

 S 735-016

 (5)  
Do this task: "Altitude Signals Test."

 S 735-038

 (6)  
Do this task: "Airspeed Signals Test."

 S 735-018

 (7)  
Do this task: "ATC Event (Radio Keying) Signals Test."

 TASK 31-24-00-865-027
 4.  Prepare for Input Parameter Test________________________________
 A. Special Tools and Equipment
 (1)  
One of these portable testers which can select SUPERFRAMES (if they are applicable), SUBFRAMES and WORDS to show the data for the flight data recorder:

 (a)  
Flight Line Tester, Teledyne P/N 2229738, Teledyne Controls, 12333 W. Olympic Blvd., West Los Angeles, CA 90064

 (b)  
Digital Signal Display unit, Sundstrand P/N 981-6301-002, Sundstrand Aviation Division, PO Box 7002 4747 Harrison Ave. Rockford, IL 61101

 (c)  
Multi-Purpose Aids Display Unit,
 AACO P/N FAA-0032-005
 AACO Inc. P.O. Box 570
 Renton, WA 98057

 (2)
Adapter Cable - Tester, Flight Data Recorder System P/N A31007

 NOTE: The tester cable consists of a cable assembly that is
____ approximately 60 inches long with a connector and a dust cap on each end. Use the -1 cable with Teledyne testers 2222786, 2227295, or 2225302. Use the -30 cable (on airplanes with FDEP) or -49 cable (on airplanes without FDEP) when using the Sundstrand tester 981-6301-002.
 B. References
 (1)  AMM 24-22-00/201, Manual Control
 C. Access
 (1)  Location Zone
 101 Control Cabin - Left
 102 Control Cabin - Right

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. B-2531 AND B-2532 ú
 31-24-00
 ú ú 09 Page 503 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 D. Procedure
 S 865-001
 (1)  
Supply electrical power (AMM 24-22-00/201).

 S 865-002

 (2)  
Make sure the engines are off.

 S 485-003

 (3)
Connect the portable tester to the flight data recorder.

 S 865-129

 (4)  
SUNDSTRAND PORTABLE TESTER; Put the portable tester switches to these positions:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(11)