(i)  
Make sure the OFF light on the test module is on.

 (j)  
Remove the flight data recorder (Ref 31-24-11/401).

 (k)  
Make sure these circuit breakers are closed: 1) C00109, FLIGHT RECORDER AC 2) C00468, FLIGHT RECORDER DC

 (l)  
Make sure the DFDR FAIL light on the FDAU is on.

 (m)  
Install the flight data recorder (Ref 31-24-11/401).

 (n)  
Make sure the OFF light on the test module is off.

 (o)  
Put the TEST--NORMAL switch in the NORMAL position.

 TASK 31-24-02-735-569
 3.  Configuration Test - Flight Recorder System___________________________________________
 A. General
 (1)  The Configuration Test checks the DFDAU and airplane configuration to find out if the DFDAU and airplane are correct for the system test that follows.
 B. References
 (1)  AMM 24-22-00/201, Manual Control
 C. Access
 (1)  Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right

 D. Procedure
 S 735-579
 (1)  
Do this task: Prepare for Input Parameters Test

 S 735-570

 (2)  
Do this EFIS input configuration test.

 (a)
Set the portable tester to SUBFRAME 3, WORD 31.

 (b)
Make sure the BIT 4 light on the portable tester is on.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 BEJ 101-112, 114-999; ú  31-24-02
 ú ú 15 Page 504 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 735-571
 (3)  Do this EIS input configuration test.
 (a)  
Set the portable tester to SUBFRAME 3, WORD 31.

 (b)  
Make sure the BIT 3 light on the portable tester is on.

 S 735-572
 (4)  Do this dataframe test.
 (a)  
Set the portable tester to SUBFRAME 3, WORD 31.

 (b)  
Make sure the BIT 5 light on the portable tester is on.

 S 735-573
 (5)  Do this DME Source test.
 (a)  
Set the portable tester to SUBFRAME 3, WORD 31.

 (b)  
Make sure the BIT 6 light on the portable tester is off.

 S 735-574
 (6)  Do this configuration discrete test.
 (a)  
Set the portable tester to SUBFRAME 3, WORD 31.

 (b)  
Make sure the BIT 2 light on the portable tester is off.

 TASK 31-24-02-735-033
 4. System Test - Flight Recorder System
____________________________________
 A. General
 (1)  
The system test has procedures to do tests of all the inputs to the flight data recorder system. You can do the tests out of sequence. You can do each test independently.

 (2)  
The tests in this procedure are written to the standard BOEING application software. If customized software is installed, part of the test may not look the same. Installation of the BOEING application software may be necessary.

 (3)  
These tasks use the word SUBFRAME 0 to make a selection of a parameter which is on all four subframes. Some portable testers do not have a switch position for subframe 0. On these test sets, make a selection of subframes 1 thru 4 when the task uses subframe 0.

 B. References
 (1)  AMM 24-22-00/201, Manual Control
 C. Access
 (1)  Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right

 D. Procedure
 S 735-036
 (1)  Do this task: Aileron Position Signals Test
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 BEJ 101-112, 114-999; ú  31-24-02
 ú ú 05 Page 505 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 735-442
 (2) Do this task:  Brake Pressure Signals Test
 S 735-443
 (3) Do this task:  Control Column Position Signals Test
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(56)