(g)  
Make sure the BIT 1 light on the portable tester is off.

 (h)  
Close the IRS-1 AC circuit breaker.

 S 865-084
 (4)  If you will do no more tests, then do this task:
 "Put the Airplane to its Usual Condition."

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 BEJ 101-112, 114-999; ú  31-24-02
 ú ú 08 Page 551 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 TASK 31-24-02-735-318
 41. IRS Transfer Switch Signals Test
________________________________
 A. Access
 (1)  Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right

 B. Procedure
 S 865-319
 (1)
Make sure you did the Prepare For Input Parameter Test task.

 S 735-320

 (2)
Do this test of the signals from the IRS transfer switch.

 (a)  
Set the portable tester to SUBFRAME 4, WORD 21.

 (b)  
Make sure the IRS transfer switch is in the NORM position.

 (c)  
Make sure the BIT 1 light on the portable tester is off.

 (d)  
Set the IRS transfer switch to the BOTH-ON-2 position.

 (e)  
Make sure the BIT 1 light on the portable tester is on.

 (f)  
Put the IRS transfer switch to the NORM position.

 S 865-321
 (3)  If you will do no more tests, then do this task: "Put the Airplane to its Usual Condition."
 TASK 31-24-02-735-161
 42. Landing Gear Position Signals Test
__________________________________
 A. Access
 (1)  Location Zones
 101 Control Cabin - Left
 102 Control Cabin - Right

 B. Procedure
 S 865-162
 (1)
Make sure you did the Prepare For Input Parameter Test task.

 S 845-370

 (2)  
Prepare for the test.

 (a)
Make sure the airplane is in the ground mode.

 (b)  
Make sure the three gears are down and locked.

 (c)  
Make sure all the landing gear doors are open.

 (d)  
Install locks on all the landing gear.

 (e)  
Make sure the hydraulic power is off.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.
 BEJ 101-112, 114-999; ú  31-24-02
 ú ú 10 Page 552 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (f)  
Make sure the LEFT GEAR, RIGHT GEAR, AND NOSE GEAR green lights (P2) come on.

 (g)  
Make sure the LEFT GEAR, RIGHT GEAR, and NOSE GEAR red lights (P2) are off.

 S 735-371
 (3)  Do this test of the position signals from the landing gear:
 (a)  
Set the portable tester to the SUBFRAMES and WORDS shown in the tables.

 (b)  
Make sure the applicable bit lights for the NOSE GREEN, RH GREEN and LH GREEN landing gear lights goes out.

 (c)  
Make sure the applicable bit light for the RED NOSE, LH RED and RH RED landing gear lights comes on.

 (d)  
Put copper shields between the downlock sensors and the actuators of the proximity switches shown in the tables.

 NOTE: Install one copper shield at a time.
____
 (e)  
Make sure the applicable green light for the landing gear goes out.

 (f)  
Make sure the applicable red light for the landing gear comes on.

 (g)  
Make sure the applicable bit light on the portable tester comes on for the green landing gear lights. ~........................................ | WORD | S/F | BIT | LANDING GEAR LIGHTS | .......................................... | 9  |  1  |  1  |  RIGHT GREEN | .......................................... | 9  |  2  |  1  |  LEFT GREEN | .......................................... |  13  |  2  |  2  |  NOSE GREEN | ..........................................
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(78)