(5)  
When you move one of the thrust levers forward to the takeoff position, the warning system operates.

 (6)  
If the flaps, the speedbrakes, or the stabilizer are not in (or move out of) the takeoff configuration, the intermittent horn operates.

 (7)  
On airplanes with a parking brake aural warning installed, an intermittent horn also operates if the parking brakes are on.

 (8)  
A leading edge and trailing edge flap position test is given at the end of these procedures.

 (a)  This test uses the L.E. WARNING TEST switch (S784) and the WARNING OVERRIDE TEST switch (S785), installed on the E3-1 shelf.
 B.  Equipment
 (1)  
Protractor - F52485-500 or 4MIT65B80307-1

 (2)  
Protractor Adapter (thrust lever) - F72952-2 or F72952-15

 C.  References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 27-51-00/201, Trailing Edge Flap System

 (3)  
AMM 29-15-00/202, Hydraulic System A, B or Standby

 D.  Access
 (1)  Location Zone
 101/102 Control Cabin

 E.  Procedure
 NOTE:____The tasks that follow are Prepare-To-Test steps. You must do these steps before each individual test.
 S 865-270
 (1)  Prepare to test.
 (a)  
Put chocks on the landing gear wheels then release the parking brake.

 (b)  
Open this circuit breaker and attach a DO-NOT-CLOSE tag:

 1)  On the load control center - right panel, P6: a) AURAL WARN
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-26-00
 ALL  ú ú 03 Page 542 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (c)  
Supply electrical power (AMM 24-22-00/201).

 (d)  
Supply hydraulic system A and B power (AMM 27-51-00/201 and AMM 29-15-00/201).

 (e)  
Move the two thrust levers to the idle position.

 (f)  
Set the stabilizer position indicator to the center of the green band +/- 1 unit.

 (g)  
Extend the flaps to the takeoff range (1, 2, 5, 10, or 15 unit detent).

 (h)  
Put the control lever for the speed brake in the DOWN detent position.

 (i)  
Put the engine start levers at the control stand in the "cutoff" position.

 (j)  
Make sure these circuit breakers are closed:

 1)  On the P6 panel:
 a) FLAP POS IND - L.E. & T.E.
 b) LND GR AIR/GND RELAY & LTS
 c) AURAL WARN
 d) INDICATOR (section 6)

 S 725-112
 (2)  Do a test of the Takeoff Warning Switches operated by the thrust levers, thrust lever No. 1 (S814), and thrust lever No. 2 (S815).
 (a)  
Do the Prepare-To-Test tasks.

 (b)  
Make sure that the thrust levers are at the idle position.

 (c)  
Put the stabilizer to a position out of the green band range as follows: 1) For the 737-300, 1.0 - 6.3 units

 (d)  
Put a protractor with an adapter on the No. 1 thrust lever and set the protractor to zero degrees (Fig. 501).

 NOTE: If you use the FMC-CDU to measure the thrust lever
____ movement, follow the instructions at the start of this procedure.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 31-26-00
 ALL  ú ú 05 Page 543 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 (e)  
Make sure this circuit breaker is closed:

 1)  On the P6 panel:
 a) AURAL WARN

 (f)  
Move the No. 1 thrust lever forward.

 1)  Make sure you hear the intermittent horn when the thrust lever is between 28 and 33 degrees forward of the idle position.

 (g)  
Move the thrust lever slowly aft.

 1)  Make sure the horn stops at or before the thrust lever is 28 degrees forward of the idle position.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 儀表 INSTRUMENTS(147)