Table 2002: REFERENCE FOR SLEEVES
Page 2009 / 2010
21-53-12
JUN 15/10
DISASSEMBLY
TASK 21-53-12-000-801-A01
1. ACTUATOR - DISASSEMBLY
A. Reason For The Job
Self-Explanatory
B. Job Set-Up Information
(1) Tools, Features and Equipment
(a) Equivalent alternatives may be used for the listed items.
REFERENCE QTY NAME
No specific 1 Standard tool kit for electronics' specialist
(2) Consumable Material
Not Applicable
(3) Referenced Information
REFERENCE PAGE BLOCK DESIGNATION
(refer to Page Block 10001) 10001 ILLUSTRATED PARTS LIST
(refer to TASK 21-53-12-300-801-A01) 6001 REPLACEMENT OF CASE ASSEMBLY PARTS (REPAIR 01)
(refer to TASK 21-53-12-300-802-A01) 6001 REPLACEMENT OF EQUIPPED PLATE PARTS (REPAIR 02)
(refer to TASK 21-53-12-300-803-A01) 6001 REPLACEMENT OF MOTOR PARTS
C. Job Set-Up Not Applicable
Page 3001
21-53-12 JUN 15/10
D. Procedure WARNING: DISCONNECT THE EQUIPMENT FROM POWER SUPPLIES OR TEST EQUIPMENT
BEFORE DISASSEMBLY.
CAUTION: WHEN DESOLDERING, CONFINE THE HEAT, AS MUCH AS POSSIBLE, TO A LIMITED AREA AT ONE TIME. USE TEMPERATURE CONTROLLED SOLDERING IRONS AND HEAT SHUNTS TO PROTECT THE COMPONENTS FROM THE EFFECTS OF HEAT.
CAUTION: ALL SEALS AND GASKETS SHALL BE SYSTEMATICALLY DISCARDED ON DISASSEMBLY. WASHERS, NUTS AND SCREWS SHALL BE DISCARDED ON
DISASSEMBLY IF DAMAGED. NOTE: THE NUMBERS IN PARENTHESIS AFTER THE COMPONENT DESCRIPTION ARE THE FIGURE AND THE ITEM NUMBERS OF THE IPL (refer to Page Block 10001). Subtask 21-53-12-020-001-A01
(1) Removal of the Cover Assembly (01-190)
CAUTION: FOR VERSIONS ABC, BEFORE TO REMOVE THE COVER ASSEMBLY (01-190), YOU MUST BEFORE REMOVE THE SCREWS THAT SECURE THE MOTOR TO THE ACTUATOR AND MOVE THE MOTOR TO DO NOT DAMAGE THE MOTOR WIRE.
(a)
For versions ABC only, move the motor to do not damage the motor wire: 1 Remove the lockwires from the Screws (01-330). 2 Remove the Screws (01-330), (01-340) and the Washers (01-350).
(b)
Remove the lockwires from the Screws (01-100), (01-140), (01-210).
(c)
Remove the Screws (01-120), (01-140) and the Washers (01-160).
(d)
Remove the Screws (01-090), (01-100), the Washers (01-110) and the Lug (01-180).
(e)
Remove the Screws (01-090), the Washers (01-110) and the upper Support (01-080).
(f)
Carefully move the Connector (03-010) and the lower Support (01-080).
(g)
Remove the Screw (01-130), the Washer (01-150) and the Nut (01-170).
(h)
Remove the Screws (01-200), (01-210) and the Washers (01-220).
(i)
Carefully move the Cover (01-270) and carefully move the Connector (03-010) in the hole of the Cover.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：LIEBHERR-AEROSPACE TOULOUSE SAS COMPONENT MAINTENANCE MANUAL(22)
