%
Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003
71-61-00
AMM
%
%
%
%
%
%
%
%
%
% B. Install the Air Filter %
Detail Steps/Work Items Key Items/References
(1) Make sure that the worm-drive clamp is in position on the air filter.
(2) Put the air filter in position on the air filter housing.
(3) Tighten the worm-drive clamp which holds the air filter. Refer to Figure 1.
(4) Connect the airplane main battery. Refer to Section 24-34.
(5) Install the engine cowlings. Refer to Section 71-11.
%
Page 202 Doc # 6.02.01 09 Jan 2003 Rev. 4
71-61-00
DA 40 Series
Power Plant
AMM
% 3. Remove/Install the Alternate Air Valve
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% A. Remove the Alternate Air Valve %
Detail Steps/Work Items Key Items/References
WARNING: DO NOT STAND WITHIN THE DANGER AREA OF THE PROPELLER. IF THE ENGINE STARTS, THE PROPELLER CAN CAUSE DEATH OR INJURY TO PERSONS. WARNING: YOU MUST MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO WORK ON THE ENGINE CONTROLS. IF THE PROPELLER TURNS IT CAN CAUSE INJURY TO PERSONS.
(1) Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE.
(2) Remove the engine cowlings. Refer to Section 71-11.
(3) Disconnect the airplane main battery. Refer to Section 24-34.
(4) Loosen the worm-drive clamp that holds the air filter to the air filter housing. Refer to Paragraph 2.
(5) Remove the bolts, nuts and washers that hold the alternate air valve to the air filter housing.
(6) Disconnect the alternate air control cable.
(7) Disconnect the hose that connects the alternate air valve to the turbo-charger inlet: S Open the worm-drive-clamp. S Pull the hose off the valve. At the alternate air valve.
(8) Move the alternate air valve clear of the airplane.
%
Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003
71-61-00
AMM
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% B. Install the Alternate Air Valve %
Detail Steps/Work Items Key Items/References
(1) Move the alternate air valve close to the engine and connect the alternate air control cable to the valve.
(2) Adjust the alternate air control cable. Refer to Paragraph 5.
(3) Install the alternate air valve on the air filter housing. Apply fire resistant sealant (Dow Corning 736 or equivalent) between air filter housing and alternate air valve.
(4) Connect the hose that connects the alternate air valve to the turbo-charger inlet: S Connect the hose to the valve. S Tighten the worm-drive clamp. At the alternate air valve.
(5) Install the air filter. Refer to Paragraph 2.
%
Page 204 Doc # 6.02.01 09 Jan 2003 Rev. 4
71-61-00
DA 40 Series
Power Plant
AMM
% 4. Remove/Install the Alternate Air Control Cable
%
%
%
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機(jī)維護(hù)手冊 DA 40 SERIES AMM 5(41)
