曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(6)  Replace the oil filter: S Open the oil filter cartridge. S Remove the oil filter. S Replace the ring seals. S Install the new oil filter. S Close the cartridge.  TAE part no. 02-7250-03703R1. Torque: 25 Nm (18.4 ft.lbf). 
(7)  Cut open the used oil filter. Look for particles of metal.  If the filter contains particles of metal, refer to the engine manufacturer. 
CAUTION: YOU MUST USE AN ENGINE OIL THAT AGREES WITH THE SPECIFICATION IN THE AIRPLANE FLIGHT MANUAL, CHAPTER 2. 
(8)  Fill the engine with new engine oil.  Refer to Section 12-10. 
(9)  Do an engine run. 
(10)  Check for oil leakage. 
(11)  Install the engine cowlings.  Refer to Section 71-11. 

%

Page 202 Doc # 6.02.01 09 Jan 2003 Rev. 4
72-01-00
Engine
AMM

% 3. Change the Gearbox Oil and Replace the Gearbox Oil Filter %
%

%
%
%

%
%
%

%

%
%
%
%
%
%
%

%

%
%
%
%

%

%
%
%

%

%
%
%

DA 40 Series

Detail Steps/Work Items  Key Items/References 
(1)  Run the engine until it reaches the normal operating temperature. Then shut-down the engine.  Refer to Section 71-01. 
WARNING: MAKE THE ENGINE IS SAFE BEFORE YOU DO ANY WORK ON THE OIL SYSTEM. IF THE ENGINE STARTS THE PROPELLER CAN CAUSE INJURY OR DEATH. 
(2)  Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE. 
(3)  Remove the engine cowlings.  Refer to Section 71-11. 
(4)  Remove the gearbox oil drain plug.  Refer to Figure 1. Use a suitable container to catch the oil. 
(5)  Drain the gearbox oil.  Use a suitable container to catch the oil. 
(6)  Remove the cover from the gearbox oil filter. 
(7)  Remove the gearbox oil filter element.  Examine the filter for signs of metal particles. If you find metal particles, refer to the engine manufacturer. 
(8)  Install the gearbox oil drain plug.  Use a new seal washer (TAE part no. 02-0710-07191R1). 
(9)  Install a new gearbox oil filter.  TAE part no. 02-06120-16107R1. 
(10)  Install the gearbox oil filter cap.  Use a new seal washer (TAE part no. 02-6120-16141R1). 
(11)  Remove the gearbox oil filler plug. 

Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003

72-01-00
AMM

%

%
%

%
%

%
%
%
%
%
%
%

DA 40 Series

Detail Steps/Work Items  Key Items/References 
CAUTION: YOU MUST USE A GEARBOX OIL THAT AGREES WITH THE SPECIFICATION IN THE AIRPLANE FLIGHT MANUAL, CHAPTER 2. 
(12)  Fill the gearbox with 1 liter (1.06 US qts) of new gearbox oil.  Refer to Section 12-10. Check oil level through gearbox oil level window. 
(13)  Install the gearbox oil filler plug.  Use a new seal washer. 
(14)  Do an engine run. 
(15)  Do a propeller control test.  Refer to Section 71-01, Paragraph 3. 
(16)  Check for oil leakage. 
(17)  Install the engine cowlings.  Refer to Section 71-11. 

%

Page 204 Doc # 6.02.01 09 Jan 2003 Rev. 4
72-01-00
Engine
AMM

% 4. Read the Engine Event Log
% CAUTION: ONLY TAE-AUTHORIZED PERSONNEL MAY DOWNLOAD DATA % FROM THE ENGINE. REFER TO TAE SERVICE BULLETIN NO. 125-% 0003.
% A. Equipment % %

%

%
%

%

Item  Quantity  Part Number 
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 5(50)