B.
Access
(1)
Location Zones
711 Nose Landing Gear
731 Landing Gear Left
741 Landing Gear Right
C.
Procedure
S 496-002
(1)
Make sure that the landing gear downlocks are installed (Ref 32-00-20/201).
(2)
Make sure that chocks are installed on the wheels.
(3)
Examine the wheels for cracks, flaked paint and corrosion.
(4)
Examine the main gear wheels for evidence that they have overheated.
S 496-003
S 216-004
S 216-005
32-45-03
ALL ú ú 01 Page 601 ú Dec 20/90
A
757
MAINTENANCE MANUAL
S 216-006
(5)
If a wheel or wheels have a flat tire or the tire is not there, do the steps that follow:
(a)
If the tire on a wheel is flat, replace the wheel and tire assembly.
(b)
If there is no tire on the wheel, discard the wheel if there is evidence that the wheel has turned on the runway without the tire.
NOTE: If an airplane is moved on a wheel without a tire, the
____ wheel is permanently damaged. Damage occurs quickly in the vertical part of the rim flange, but you cannot always see the damage. If such a wheel is used again, the wheel rim flange will usually break suddenly into small pieces. Thus, no repairs are permitted although damage is not always apparent.
S 216-007
(6) Examine the hubcaps for loose retainer bolts. Tighten or replace
the bolts as necessary.
S 216-008
(7) Examine the tiebolt installations for:
(a) Loose tiebolts and tiebolt nuts
(b) Damaged tiebolts
(c) Tiebolt locations that do not have tiebolts.
S 026-009
(8) If you found a loose or damaged tiebolt or a tiebolt location
without a tiebolt, remove the wheel (Ref 32-45-01/401, Main Wheel--
32-45-02/401, Nose Wheel).
S 216-010
(9) If you removed the wheel, do the steps to examine the wheel with the
wheel removed from the airplane.
NOTE:____ Carefully examine the wheel for damage and broken parts.
S 216-011
(10)
If you removed a main wheel, examine the brake for damage and broken parts.
S 216-012
(11)
Do a check to make sure that the rotor drive keys are firmly attached. Tighten the nuts as necessary.
32-45-03
ALL ú ú 01 Page 602 ú May 28/01
A
757 MAINTENANCE MANUAL
TASK 32-45-03-216-013
3. Examine the Wheels (Wheel Removed from Airplane) (Fig. 601)________________________________________________
A. References
(1)
32-00-20/201, Landing Gear Downlocks
B.
Access
(1)
Location Zones
711 Nose Landing Gear
731 Landing Gear Left
741 Landing Gear Right
C.
Procedure
S 216-014
(1) Examine the metal parts of the wheel for the types of damage
that follow:
breaks,
cracks,
nicks,
scratches,
scoring,
stripped or crossed thread,
corrosion,
distortion,
worn plating,
gouging
other damage
S 216-015
(2)
Examine the seal retainers for cracks, distortion, or surface damage.
S 216-016
(3)
Examine the grease seals for nicks or gouges and evidence that they have overheated.
S 216-017
(4) 中國航空網 www.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：757 AMM 飛機維護手冊 起落架 CHAPTER 32 - LANDING GEAR 3(79)
