(0.00 to 9.00 lbf.ft)
 No specific Torque Wrench : range 0.20 to 3.60 m.daN

 (2.00
 to 26.00 lbf.ft) 98A49107504001 1 PROTECTOR - THREADS, APU MOUNTING BOLTS

 B.
 Consumable Materials

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 05-002  USA MIL-P-8116 PUTTY, ZINC CHROMATE GENERAL PURPOSE (Ref. 20-31-00)
 Material No. 05-027  USA MIL-L-81309
 RUST INHIBITOR(FOR CORROSION USE 15-004)
 (Ref. 20-31-00)

 Material No. 11-001  USA MIL-D-16791 TYPE I
 DETERGENT (Ref. 20-31-00)

R  EFF : 001-049, 101-105, 107-107, 151-199, 49-12-52Page 408 201-210, Config-2 Aug 01/05
 CES  C. Expendable Parts

 -------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION  |IPC-CSN
 -------------------------------------------------------------------------------
3 cotter pin 49-12-04 03 -110 3 cotter pin 49-12-04 03A-110 11 cotter pin 49-12-04 03 -100 11 cotter pin 49-12-04 03A-100 21 cotter pin 49-12-04 03 -100 21 cotter pin 49-12-04 03A-100
 D. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action 29-14-00-614-002 Pressurization of the Hydraulic Reservoirs through
 the Ground Connector 49-00-00-080-003 Removal of the APU Hoist Tool (131-9(A)) 52-41-00-010-001 Open the APU Doors for Access 52-41-00-410-001 Close the APU Doors after Access 52-41-21-000-001 Removal of the APU Access Door 315AL 52-41-22-000-001 Removal of the APU Access Door 316AR and the related
 Door Mechanism
 **ON A/C 001-049, 101-105, 201-203,
 49-12-52-991-003 Fig. 401
R  **ON A/C 107-107, 151-199, 204-210,
 49-12-52-991-003-A Fig. 401A

R  EFF : 001-049, 101-105, 107-107, 151-199, 49-12-52Page 409 201-210, Config-2 Aug 01/05
 CES

R  **ON A/C 001-049, 101-105, 107-107, 151-199, 201-210,
 3. Job Set-up
__________
 Subtask 49-12-52-860-057

 A. Aircraft Maintenance Configuration
 (1)
 Make sure that the ground service network is energized (Ref. TASK 24-42-00-861-001).

 (2)
 On the panel 25VU make sure that the APU MASTER SW p/bsw is OFF.

 (3)
 Make sure that the warning notices is on panel 25VU to tell persons not to start the APU.

 (4)
 Make sure that hydraulic systems are depressurized
 (Ref. TASK 29-00-00-864-001).

 (5)
 Make sure that the access platform is in position below the access doors 315AL and 316AR.

 (6)
 Make sure that the APU access doors 315AL, 316AR are open (Ref. TASK 52-41-00-010-001) or removed (Ref. TASK 52-41-21-000-001) and (Ref. TASK 52-41-22-000-001).

 (7)
 Make sure that the LIGHT SW 11LJ is set to the ON position.
 Subtask 49-12-52-865-058

 B.
 Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged

 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41
 4. Procedure
_________
 **ON A/C 001-049, 101-105, 201-203,

 (Ref. Fig. 401/TASK 49-12-52-991-003)

R  EFF : 001-049, 101-105, 107-107, 151-199, 49-12-52Page 410 201-210, Config-2 Aug 01/05
 CES

R  **ON A/C 107-107, 151-199, 204-210,
 (Ref. Fig. 401A/TASK 49-12-52-991-003-A) R **ON A/C 001-049, 101-105, 107-107, 151-199, 201-210,
 Subtask 49-12-52-210-055
 A. Preparation for Installation
 (1)
 Clean the tie-rods (4) and (6) and the vibration isolator (16) with solvent CLEANING AGENTS (Material No. 11-001) and a fiber-bristled brush.

 (2)
 Do a check and make sure that the tie-rods (4) and (6) are in correct condition.

 (3)
 If the tie-rods and/or the vibration isolator are damaged, replace them if necessary.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 機載輔助動力 AIRBORNE AUXILIARY POWER2(95)