- AMU (1RN)
- ACP-CAPT (2RN1)
- ACP-F/O (2RN2)
- ACP-3RD OCCPNT (2RN3)
- wiring
- SW-RAD PTT, CAPT (11RN)
- RCPT-HAND MIC, CAPT (19RN1)
- SW-RAD PTT, F/O (12RN)
- RCPT-HAND MIC, F/O (19RN2)
- RCPT-HAND MIC, F/O (19RN3)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION
-------------------------------------------------------------------------------
IPC 235108
AMM 23-11-00-710-001 Operational Test of the HF System
AMM 23-11-33-000-001 Removal of the HF Transceiver (3RE1, 3RE2)
AMM 23-11-33-400-001 Installation of the HF Transceiver (3RE1, 3RE2)
AMM 23-51-12-000-001 Removal of the Audio Control Panel (ACP) (2RN1, 2RN2,
2RN3, 2RN4, 2RN5) AMM 23-51-12-400-001 Installation of the Audio Control Panel (ACP) (2RN1,
2RN2, 2RN3, 2RN4, 2RN5) AMM 23-51-34-000-001 Removal of the Audio Management Unit (AMU) (1RN) AMM 23-51-34-400-001 Installation of the Audio Management Unit (AMU) (1RN) AMM 27-92-41-000-001 Removal of the Side Stick Assembly 19VU (18VU) AMM 27-92-41-400-001 Installation of the Side Stick Assembly 19VU (18VU) ASM 23-11/01 ASM 23-51/02 ASM 23-51/03 ASM 23-51/04 ASM 23-51/06
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-11-00∞∞∞∞∞∞∞∞∞∞Page 213
Aug 01/02 CES
3. Fault Confirmation
__________________
A. Test
(1) Do the operational test of the HF system (Ref. AMM TASK 23-11-00-710-001).
NOTE : Do the transmission test for more than 60 s to see the ECAM
____ warning on the upper ECAM DU. (The COM HF 1 EMITTING message comes into view after 60 s of continuous transmission).
NOTE : Do this test at each crew station to find which station is
____
related with the failure.
NOTE : Do this test for the HF 1 system only.
____
NOTE : At the end of the test (before you do the fault isolation
____ procedure), make sure that these controls are not in the transmit position:
- the HF 1 transmission pushbutton switch on an Audio Control Panel
- a radio PTT switch on one of the two side sticks
- a radio PTT pushbutton switch
- a hand mike selector.
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R **ON A/C 001-049, 101-105, 151-199,
49VU COM/HF1 1RE1 HA14 R **ON A/C 051-099, 106-149, 201-299, 301-399,
49VU COM HF1 1RE1 HA14
**ON A/C ALL
B. After 60 s, when the HF 1 transmission stops, this ECAM warning does not go out of view:
- COM HF 1 EMITTING.
(1) If the above warning does not go out of view after action on the HF 1 transmission pushbutton switch (green bars off) (on the ACP of the related station):
- go to Para. 4.B.
(2) If the above warning goes out of view after action on the HF 1 transmission pushbutton switch (green bars off) (on the ACP of the related station):
- go to Para. 4.C.
C. Open the circuit breaker (1RE1) on the panel 49VU, then close it.
(1) If the fault continues:
- do a check for ground at the pin AB/2E of the HF 1 transceiver (3RE1) (Ref. ASM 23-11/01).
(a) If there is no ground signal at this pin:
- do a check and repair the wiring from HF 1 transceiver (3RE1) pin AB/2E to the first terminal block (Ref. ASM 23-11/01).
(b) If there is a ground signal at this pin:
- replace the XCVR-HF, 1 (3RE1) (Ref. AMM TASK 23-11-33-000-001) and (Ref. AMM TASK 23-11-33-400-001).
1_ If the fault continues:
- replace the AMU (1RN) (Ref. AMM TASK 23-51-34-000-001) and
(Ref. AMM TASK 23-51-34-400-001).
2_ If the fault continues:
- do a check and repair the wiring from AMU (1RN) pin AA/4F to
HF 1 transceiver (3RE1) pin AB/1C (Ref. ASM 23-51/06).
- go to Para. 4.D.
D. The fault is at one of the 3 crew stations.
(1) If the fault is at the Captain station:
- do a check of continuity between pin AA/9J and pin AA/9K of the AMU (1RN) (Ref. ASM 23-51/02).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 COMMUNICATIONS 通訊1(46)
