- replace the XCVR-VHF, 2 (1RC2), (Ref. AMM TASK 23-12-33-000-001) and (Ref. AMM TASK 23-12-33-400-001).
(b) If there is no 28DC:
- do a check for a ground signal at pin AB/3D of the VHF 2 transceiver (1RC2) (Ref. ASM 23-12/02).
1 If there is no ground signal:
_
- repair the wiring between the VHF 2 transceiver pin AB/3D and the ground terminal (Ref. ASM 23-12/02).
2 If there is a ground signal:
_
- do a check of the wiring between the VHF 2 transceiver pin AC/2 and the circuit breaker 2RC2 (Ref. ASM 23-12/02).
a If there is no continuity:
_ - repair the above wiring.
b If there is continuity:
_
- replace the circuit breaker 2RC2.
(2) If the circuit breaker is open:
- close it.
(a) If it opens again:
- replace the VHF 2 transceiver (Ref. AMM TASK 23-12-33-000-001) and (Ref. AMM TASK 23-12-33-400-001).
1 If the fault continues:
_
- do a check for a short-to-ground at the wiring between the VHF 2 transceiver pin AC/2 and the circuit breaker 2RC2 (Ref. ASM 23-12/02).
a If there is a short-to-ground:
_ - repair the related wiring
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-12-00∞∞∞∞∞∞∞∞∞∞Page 205
Aug 01/05 CES
R b_ If there is no short-to-ground:
R - replace the C/B-COM NAV/VHF/2 (2RC2).
R (b) If the circuit breaker stays closed and the fault continues:
R - replace the VHF 2 transceiver (Ref. AMM TASK 23-12-33-000-001)
R and (Ref. AMM TASK 23-12-33-400-001).
R **ON A/C ALL
C. Do the test given in Para. 3.
TASK 23-12-00-810-804
Loss of the VHF 1 COMMUNICATION
1. Possible Causes
_______________
- XCVR-VHF, 1 (1RC1)
- ANTENNA-VHF, 1 (4RC1)
- coaxial from the VHF 1transceiver (1RC1) to the VHF 1 antenna (4RC1)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R ESPM 204416W01 AMM 23-12-00-740-001 BITE Test of the VHF System AMM 23-12-11-000-001 Removal of the VHF Antennas (4RC1) and (4RC2) AMM 23-12-11-400-001 Installation of the VHF Antennas (4RC1) and (4RC2) AMM 23-12-33-000-001 Removal of the VHF Transceiver (1RC1, 1RC2, 1RC3) AMM 23-12-33-400-001 Installation of the VHF Transceiver (1RC1, 1RC2,
1RC3) ASM 23-12/01 R
3. Fault Confirmation
__________________
A. Test
(1) Do the BITE test of the VHF system (Ref. AMM TASK 23-12-00-740-001).
NOTE : Do this test for the VHF 1 only.
____
4. Fault Isolation
_______________
R **ON A/C 051-061, 106-149, 201-299, 301-399, 401-499,
A. If the test gives the maintenance message VHF1 ANTENNA (4RC1)/COAX:
- replace the XCVR-VHF, 1 (1RC1), (Ref. AMM TASK 23-12-33-000-001) and (Ref. AMM TASK 23-12-33-400-001).
(1) If the fault continues:
- replace the ANTENNA-VHF, 1 (4RC1), (Ref. AMM TASK 23-12-11-000-001) and (Ref. AMM TASK 23-12-11-400-001).
R R (2) If the fault continues: - do a check and repair the coaxial from the VHF 1transceiver (1RC1) to the VHF 1 antenna (4RC1) (Ref. ASM 23-12/01) and (Ref. ESPM 204416W01).
**ON A/C ALL
B. Do the test given in Para. 3.
TASK 23-12-00-810-805
Loss of the VHF 2 Communication
1. Possible Causes
_______________
- XCVR-VHF, 2 (1RC2)
- ANTENNA-VHF, 2 (4RC2)
- coaxial from the VHF 2 transceiver (1RC1) to the VHF 2 antenna (4RC2)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R ESPM 204416W01 AMM 23-12-00-740-001 BITE Test of the VHF System AMM 23-12-11-000-001 Removal of the VHF Antennas (4RC1) and (4RC2) AMM 23-12-11-400-001 Installation of the VHF Antennas (4RC1) and (4RC2) AMM 23-12-33-000-001 Removal of the VHF Transceiver (1RC1, 1RC2, 1RC3) AMM 23-12-33-400-001 Installation of the VHF Transceiver (1RC1, 1RC2,
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 COMMUNICATIONS 通訊1(61)
