曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 NOTE: Do not install more than a total of 20 clips.
____
 WARNING: MAKE SURE THAT THE NOZZLE AND EXHAUST CONE ARE
_______ SUFFICIENTLY COOL. IF THE NOZZLE AND EXHAUST CONE ARE TOO HOT, INJURIES TO PERSONS CAN OCCUR WHEN THEY INSTALL THE BALANCE CLIPS.
 (j)  Remove the clips that will not be used again with uncrimping pliers as follows: 1) Move the blade with the clip which is to be removed to the
 6 o'clock position. 2) Engage the tool head over the blade tip shroud on the right side of the clip (Fig. 521).
 3)  Move the tool head left and engage the clip retaining pin of the tool between the clip and the rear of the blade tip shroud.
 4)  Engage the rear end of the clip in the window of the tool head lower jaw. 5) Press the trigger of the tool handle to unlock the antirotation plate. 6) Push the tool rod forward and slightly upward to tilt the tool end-fitting and uncrimp the clip.
 CAUTION: WHEN YOU REMOVE THE TOOL AND THE CLIP, MAKE SURE THAT
_______ YOU TURN THE TOOL CLOCKWISE TO KEEP THE CLIP OUT OF THE TURBINE. THE CLIP CAN FALL INTO THE TURBINE IF YOU TURN THE TOOL COUNTERCLOCKWISE. DAMAGE TO EQUIPMENT CAN OCCUR.
 7)  Turn the tool clockwise a quarter of a turn and pull it back together with the clip.
 S 435-043-C00
 (8)  If there are no balance clips (Ref: AIPC 72-56-00-15, item 45) on the engine already, install the balance clips as follows.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-00
 ALL  ú ú C02 Page 570 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////

 Intervectorial Analysis Optimization Worksheet
Figure 516

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-00
 ALL  ú ú C02 Page 571 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
E06689
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////

S-M56-MM-02184-02-B
SENSITIVITY VALUES WITH THE ENGINE SOFT MOUNTING (LORD) SENSITIVITY VALUES WITH THE ENGINE HARD AFT MOUNT (BARRY) PHASE LAG WITH THE SPECTRAL DYNAMIC ANALYZER

CONFIGURATION ONE

LPT Trim Balance Worksheet
Figure 517 (Sheet 1)

E06737
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-00
 ALL  ú ú C02 Page 572 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////

PHASE LAG WITH THE SPECTRAL DYNAMIC ANALYZER
CONFIGURATION TWO

LPT Trim Balance Worksheet
Figure 517 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-00
 ALL  ú ú C02 Page 573 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////

____NOTE:  DO NOT INSTALL MORE THAN 20 CLIPS  S-M56-MM-02073-00-B 
Balance Clip Distribution Table Figure 518 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-00
 ALL  ú
 ú  C02  Page 574
 ú  Mar 15/94 

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 ENGINE 發動機 1(102)