S 864-018-C00

 (3)  
Make sure you close these circuit breakers:

 (a)  Main Power Distribution Panel P6
 1) ENG 1 START VALVE
 2) ENG 2 START VALVE

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-01
 ALL  ú ú C02 Page 407 ú Jul 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
SPINNER - INSPECTION/CHECK
__________________________
 1.  General
_______
 A.  This procedure gives the visual inspection procedures for the spinner front and rear cone.
 B.  Access to the spinner is from the engine inlet.
 TASK 72-31-01-216-001-C00
 2.  Spinner Inspection
__________________
 A.  Consumable Materials
 (1)  Loctite 496 (CP2216)
 B.  References
 (1)  
72-31-01/401, Spinner

 (2)  
AMM 72-55-00/201, Low Pressure Turbine Shaft Module

 C.  Access
 (1)  Location Zones
 501 Engine No. 1 - Inlet Cowl
 601 Engine No. 2 - Inlet Cowl
 506 Engine No. 1 - Fan Disk
 606 Engine No. 2 - Fan Disk

 D.  Procedure
 S 216-004-C00
 (1)  Do a visual check of the spinner front and rear cones for damage as follows (Fig. 601):
 (a)  
Cracks in the two elliptical spinners. 1) Cracks in the two spinners are not serviceable. 2) If you find cracks in the spinners, replace the front

 and/or rear cone (AMM 72-31-01/401).

 (b)  
Dents on the spinner. 1) The is no maximum limit to the number of dents.

 (c)  
Damage to the surface protection of the elliptical spinner front and rear cone. 1) It is permitted to have up to 100 percent of the total

 surface damaged.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-01
 ALL  ú ú C02 Page 601 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
(d)  
Corrosion marks (white mushroom pattern) on the front spinner. 1) These corrosion marks are not serviceable. 2) Replace the front spinner (AMM 72-31-01/401). 3) A maximum service extension of 100 cycles is permitted.

 (e)  
Contact marks on the bonded lip seal (Fig. 602).

 1)  Contact marks on the bonded lip seal are permitted without limit.

 (f)  
Tears on the bonded lip seal. 1) All tears on the bonded lip seal are permitted.

 (g)  
Missing bonded lip seal. 1) It is permitted to have a missing lip seal.

 (h)  
Oil wetting of the inner surface of the spinner cone, the fan disk, or the forward fan shaft. 1) None permitted. Replace the O-rings on the LPT shaft plug

 (AMM 72-55-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-01
 ALL  ú ú C02 Page 602 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////

Spinner Inspection
Figure 601

A09488
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 72-31-01
 ALL  ú ú C02 Page 603 ú Jul 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
　
中國航空網(wǎng) www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 ENGINE 發(fā)動機 1(127)