S 865-173-C00
(2)
During a subsequent engine operation, do a check of the N1 and AVM indications to make sure they operate correctly.
TASK 72-31-00-755-160-C00
8. AIRPLANES WITH THE ENDEVCO S360N021-213 AVM;
In-Flight Data Trim Balance Procedure
______________________________________
A. General ú (1) The trim balance feature of this unit does not function correctly on ú 737-300/400/500 airplanes, refer to 737-SL-77-015.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-31-00
ALL ú ú C09.1 Page 582Q ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
SPINNER - REMOVAL/INSTALLATION
______________________________
1. General
_______
A. This procedure contains two tasks for the removal and installation of the spinner front and rear cones.
B. Access to the spinner is from the engine inlet.
C. The spinner is removed for repair, replacement and for the fan blade removal and installation.
TASK 72-31-01-004-001-C00
2. Spinner Removal
_______________
A. General
(1) This task contains three steps:
-Prepare to Remove the Spinner
-
Remove the Spinner Front Cone
-
Remove the Spinner Rear Cone
B. Equipment
(1)
Tool set - jackscrews, 856A1130P08 and P11,
CFM International, P.O. Box 15514,
Cincinnati, OH 45215
(2)
Puller tool set - spinner rear cone, 856A2601,
CFM International (optional to 856A1130P11).
(3)
Protective mats (two necessary) -Rubber Manufacturer's Association, Grade SC43,
neoprene sponge, 1.0 inch thick, approximately
3.0 x 4.0 feet with warning streamers attached
C. Access
(1) Location Zones
101 Flight Compartment, Left
102 Flight Compartment, Right
501 Engine No. 1 - Inlet Cowl
601 Engine No. 2 - Inlet Cowl
506 Engine No. 1 - Fan Disk
606 Engine No. 2 - Fan Disk
D. Prepare to Remove the Spinner
S 864-002-C00
(1) Make sure the start levers are in the CUTOFF position.
(a) Install the DO-NOT-OPERATE tags.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
72-31-01
ALL ú ú C01 Page 401 ú Jul 15/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 864-019-C00
(2) Make sure you open these circuit breakers:
(a) Main Power Distribution Panel P6
1) ENG 1 START VALVE
2) ENG 2 START VALVE
S 494-004-C00
CAUTION:_______MAKE SURE YOU INSTALL THE MATS IN THE INLET COWL. THIS WILL PREVENT DAMAGE FROM TOOLS, PARTS OR UNWANTED MATERIAL THAT FALL ON THE INLET COWL.
(3) Install the mats into the lower half of the inlet cowl.
E. Remove the Spinner Front Cone (Fig. 401)
S 034-005-C00
CAUTION: MAKE SURE THE SPINNER FRONT CONE DOES NOT FALL WHEN IT
_______ DISCONNECTS FROM THE SPINNER REAR CONE. IF YOU DO NOT OBEY THIS PRECAUTION, DAMAGE TO THE CONE CAN OCCUR.
(1) Disconnect the spinner front cone from the spinner rear cone.
(a) Remove the eight bolts and washers that attach the spinner front cone to the spinner rear cone.
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 ENGINE 發動機 1(124)
