S 864-085
 WARNING: IT IS IMPORTANT THAT ALL OF THE CROSSFEED VALVES ARE CLOSED
_______ WHEN THE FUEL STRAINER HOUSING IS DISCONNECTED. IF A CROSSFEED VALVE IS OPEN, A FUEL SPILL CAN OCCUR WHEN FUEL FROM A MAIN TANK FLOWS INTO THE FUEL-FEED MANIFOLD AND DRAINS OUT OF THE SCAVENGE SYSTEM TUBING. A FUEL SPILL CAN CAUSE INJURY TO PERSONS AND DAMAGE TO THE AIRPLANE.
 (4)  
Make sure all of the control switches for the fuel crossfeed valves (fuel management control module, P5 panel) are in the off position (the flowbar on the switch goes out).

 (5)  
Defuel the center wing tank (AMM 28-26-00/201).

 S 654-028
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-15-12
 ALL  ú ú 03 Page 402 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-029
 WARNING:_______OBEY ALL THE FUEL TANK PURGING AND ENTRY PRECAUTIONS. YOU CAN CAUSE AN INJURY TO A PERSON AND CAUSE DAMAGE TO THE AIRPLANE.
 (6)  
Remove all the fuel in the center wing tank and prepare the center wing tank for an entry (AMM 28-11-00/201).

 F.
Remove the Fuel Strainer Housing

 S 034-096
 (1)  
Go into the applicable wheel well for the wing landing gear to get to the cap for the fuel strainer housing.

 S 034-053

 (2)  
Remove the lockwire between the bolt on the rear spar and the nut on the fuel strainer housing.

 S 024-082

 (3)
Remove the jamnut and the washer from the fuel strainer housing.

 S 864-054
 WARNING:_______OBEY ALL THE FUEL TANK PURGING AND ENTRY PRECAUTIONS. YOU CAN CAUSE AN INJURY TO A PERSON AND CAUSE DAMAGE TO THE AIRPLANE.
 (4)  
Go into the center wing tank.

 S 014-058

 (5)  
Remove these spanwise beam access doors (AMM 28-11-09/401):

 (a)  
131AZ

 (b)  
131BZ

 (c)  
132CZ (fuel scavenge system into the No. 2 main tank)

 (d)  
132AZ (fuel scavenge system into the No. 3 main tank)

 S 034-094
 (6)  
Disconnect or loosen the bonding jumpers and the tube support brackets if it is necessary.

 (7)  
Remove the lockwire from the union (2 locations).

 S 034-047
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-15-12
 ALL  ú ú 03 Page 403 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 864-086
 (8)  Put the fuel container in position to collect the fuel that remains in the fuel-feed manifold.
 NOTE: The quantity of fuel that can drain from the fuel-feed
____ manifold when the fuel strainer housing is removed is 20 gallons (76 liters).
 S 034-055
 (9)  
Disconnect the fuel tube (2 locations) from the fuel strainer housing.

 S 024-098

 (10)
 Remove the fuel strainer housing.

 (a)  
Discard the O-ring.

 S 144-061
 (11) Remove the unwanted sealant from the fuel strainer housing area.
 TASK 28-15-12-404-034
 3. Fuel Strainer Housing Installation (Fig. 401)
__________________________________
 A. General
 (1)  
The installation of the two fuel strainer housing assemblies is almost the same.

 B.
Standard Tools and Equipment

 (1)  
Bonding Meter (SWPM 20-20-00) Approved for use in a fuel vapor area.

 (2)  
Container - used to contain fuel

 C.
Consumable Materials

 (1)  
D00128 Petrolatum - Technical, VV-P-236

 (2)  
Use one of these sealants:

 (a)  
A00908 Sealant - Pro-Seal 860, B 1/6

 (b)  
A00702 Sealant - BMS 5-26 Type II Class B

 D.
References

 (1)  
AMM 12-11-01/301, Fuel Servicing

 (2)  
AMM 28-11-00/201, Fuel Tanks

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 燃油 FUEL 1(169)