6.
3.7擾流板手柄 -------------------------------------------------------------------------------------------DOWN

6.3.8襟翼手柄
---------------------------------------------------------------------------------------------------UP

6.3.9油門桿
----------------------------------------------------------------------全行程檢查后放“IDLE”位

6.
3.10反推手柄 ---------------------------------------------------------------------------------------------STOW

6.
3.11起動手柄 -----------------------------------------------------------------------------------------CUT OFF

6.3.12時鐘
------------------------------------------------------------------------------------------------工作正常

6.
3.13燃油箱油量 ---------------------------------------------------------每邊油箱至少 1750磅（794 Kg）

6.
3.14 發動機指示系統 ---------------------------------------------------------------------------------------正常 N1------------------------------0  OIL  PRESS------------------------------0

6.
3.15液壓油量 ---------------------------------------------------------------------------------正常，不夠添加

6.
3.16防滯剎車電門 ------------------------------------------------------------------------------------------OFF 

6.
3.17自動剎車選擇旋鈕 ------------------------------------------------------------------------------------OFF 

6.
3.18起落架手柄 -----------------------------------------------------------------------------DOWN，綠燈亮

6.
3.19儲壓器壓力表指針 ------------------------------------------------------------------------------------綠區

6.
3.20主警告燈及信號牌 ---------------------------------------------------------------------檢查，工作正常

6.
3.21航行燈、防撞燈 ----------------------------------------------開，夜間還要開機翼照明燈、航徽燈

6.
3.22后溢流活門 ------------------------------------------------------------全開，且表指與實際位置一致

6.3.23空
/地選擇電門（僅適用模擬式增壓控制面板） -----------------------------------------------GND

6.3.24
APU引氣電門 -------------------------------------------------------------------------------------------ON

6.3.25
 APU引氣壓力 --------------------------------------------------------------------------------大于 30 PSI

6.
3.26發動機引氣電門 --------------------------------------------------------------------------------------OFF

6.
3.27隔離活門電門 ---------------------------------------------------------------------------------------OPEN 

6.
3.28左、右組件電門 --------------------------------------------------------------------------------------OFF

6.
3.29風檔加溫電門 -----------------------------------------------------------------------------------------OFF

6.
3.30皮托管加溫電門 --------------------------------------------------------------------------------------OFF 

6.
3.31機翼熱防冰電門 --------------------------------------------------------------------------------------OFF 

6.
3.32發動機進氣道熱防冰電門 ---------------------------------------------------------------------------OFF

6.3.33
 EDP電門（ENG 1）----------------------------------------------------------------------------------ON

6.3.34
EDP電門（ENG 2）----------------------------------------------------------------------------------ON

6.3.35
 EMDP電門（ ELEC 1）-------------------------------------------------ON，且壓力大于 2950PSI

6.3.36
EMDP電門（ ELEC 2）-------------------------------------------------ON，且壓力大于 2950PSI

3.6.37門警燈
--------------------------------------------------------------------------------------------全部熄滅

6.
3.38設備冷卻電門 -----------------------------------------------------------------------------正常或備用位
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：B737-300 飛機發動機試車培訓大綱(5)