EFF : ALL
25-23-45Page 426
Nov 01/02
INTENTIONALLY BLANK
R Door Frame Linings at the AFT Passenger/Crew Door, left Side R Figure 403/TASK 25-23-45-991-004-A12 (SHEET 1)
EFF : ALL
25-23-45Page 428
Nov 01/02 CES
R Door Frame Linings at the AFT Passenger/Crew Door, left Side R Figure 403/TASK 25-23-45-991-004-A22 (SHEET 2)
EFF : ALL
25-23-45Page 429
Nov 01/02 CES
(b)
Put CAP - BLANKING, PLASTIC on the disconnected electrical connectors.
(c)
Loosen the clamp (6) and disconnect the hose (5).
(d)
Put PLUG - BLANKING, PLASTIC on the disconnected line ends.
(e)
Hold the lining 261VW in position.
(f)
Remove the caps (3), the screws (1), (4) and (8), the washers (2) and (7) and remove the lining 261VW.
(2)
Remove the lining 261UW:
(a) Remove the screws (1) and the washers (2) and the lining 261UW.
(3)
Remove the lining 261TW:
(a)
Remove the screws (16), the washers (17) and the latch hook (18).
(b)
Remove the handgrip: CAUTION : DO NOT USE TOO MUCH FORCE WHEN YOU REMOVE THE COVER AS
_______ THIS CAN CAUSE DAMAGE TO THE RETAINER.
(c)
Remove the cap (3), the screws (4) and (1) and the washers (2).
(d)
Carefully tilt the lining, remove the nuts (22) and disengage the socket (23) .
(e)
Remove the lining 261TW.
1_ Put a SCREWDRIVER - SMALL with a flat blade between the
handgrip cover (9) and the handgrip (14).
2_ Carefully push the the lugs (10) of the handgrip cover (9) in
the direction of the arrows and remove the handgrip cover (9).
3_ Remove the screws (11) and (12), the plates (13), the spacer
(15) (if installed) and the handgrip (14).
EFF : ALL
25-23-45Page 430
May 01/03
R
CES (4) Remove the lining 261WW:
(a)
Remove the cap (3), the screws (4) and (1) and the washers (2).
(b)
Remove the handgrip: CAUTION : DO NOT USE TOO MUCH FORCE WHEN YOU REMOVE THE COVER AS
_______
THIS CAN CAUSE DAMAGE TO THE RETAINER.
1_ Put a SCREWDRIVER - SMALL with a flat blade between the
handgrip cover (9) and the handgrip (14).
2_ Carefully push the the lugs (10) of the handgrip cover (9) in
the direction of the arrows and remove the handgrip cover (9).
3_ Remove the screws (11) and (12), the plates (13), the spacer
(15) (if installed) and the handgrip (14).
(c) Remove the lining 261WW.
EFF : ALL
25-23-45Page 431
May 01/03
R
CES TASK 25-23-45-400-008
Installation of the Door Frame Linings at the Left AFT Passenger/Crew Door
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific Torque Wrench : range 0.00 to 1.20 m.daN
(0.00 to 9.00 lbf.ft)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
11-00-00-400-002 Installation of the Decals 20-21-11-911-001 Tightening Torques for Standard Threaded Fasteners 23-73-13-400-001 Installation of the AFT Attendant Panel 126RH 23-73-22-400-001 Installation of the Attendant Indication Panel 320RH
R 23-73-44-400-001 Installation of the Handset/Cradle 24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
the External Power
33-51-11-400-001 Installation of the Cabin Emergency Light
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備2(26)
