(6)
 Close the access panel 192MB.

 (7)
 Energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-861-002).

 (8)
 Do the EIS start procedure (ECAM only) (Ref. TASK 31-60-00-860-001), then:

 (a)
 On the ECAM control panel (CP), push (in) the fuel P/BSW.

 (b)
 Make sure that the FUEL PAGE shows on the ECAM lower display unit (DU).

 Subtask 28-12-41-790-053
 D. Check for Fuel Transfer
 (1) Monitor the ECAM lower DU for 10 minutes. Make sure that the fuel in the LH wing tank does not move into the center tank.
 1EFF : ALL 1 28-12-41Page 429 1 1 May 01/04 1 1 1CES 1 Subtask 28-12-41-650-052

 E. Fuel Configuration
 (1) Refuel, defuel or transfer fuel as necessary (Ref. TASK 12-11-28-650-003), (Ref. TASK 28-25-00-650-001) or (Ref. TASK 28-25-00-869-001).
 Subtask 28-12-41-410-059
 F. Close Access
 (1) Remove the access platform(s).
 (2) Close the LH MLG door (Ref. TASK 32-12-00-410-001). Subtask 28-12-41-860-057
 G. Aircraft Maintenance Configuration
 (1)
 Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).

 (2)
 De-energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-862-002).

 Subtask 28-12-41-942-056
 H. Removal of Equipment
 (1)
 Remove the safety barriers.

 (2)
 Remove the warning notice(s).

 (3)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 1EFF : ALL 1 28-12-41Page 430 1 1 May 01/04R 1 1 1CES 1

 PROTECTOR - OVERPRESSURE - INSPECTION/CHECK
___________________________________________ TASK 28-12-41-200-003 Inspection of the Overpressure Protector 46QM (47QM) WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
 START A TASK ON OR NEAR:

 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE. WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific safety barriers
 No specific access platform 4 m (13 ft. 1 in.)

 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
28-00-00-910-001 Fuel Safety Procedures
 28-12-45-000-001 Removal of the Panel Assembly 550CB(650CB)
 28-12-45-400-002 Installation of the Panel Assembly 550CB(650CB)
 28-25-00-650-001 Pressure Defuel
 28-25-00-869-001 Fuel Transfer

R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
 28-12-41-991-001 Fig. 601
 1EFF : ALL 1 28-12-41Page 601 1 1 Aug 01/05 1 1 1CES 1 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

**ON A/C 301-399,
 28-12-41-991-001-A Fig. 601A
 **ON A/C ALL

 3. Job Set-up
__________
 Subtask 28-12-41-941-052

 A. Safety Precautions WARNING : OBEY THE SAFETY PROCEDURES WHEN YOU DO WORK IN A FUEL TANK.
_______
R (1) You must obey the fuel safety procedures (Ref. TASK 28-00-00-910-001) R when you do work on the fuel system.
 (2) Put the safety barriers in position.
 Subtask 28-12-41-650-055

 B. Fuel Configuration
 (1)
 Defuel the Surge Tank (Ref. TASK 28-25-00-650-001).

 (2)
 Drain the remaining fuel from the applicable surge tank (Ref. TASK 28-25-00-869-001).

 Subtask 28-12-41-010-053
 C. Get Access
 (1)
 Put the access platform below the applicable access panel 550CB(650CB).

 (2)
 Remove the applicable access panel 550CB(650CB) (Ref. TASK 28-12-45-000-001).
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油2(4)