WARNING : OBEY THE SAFETY PROCEDURES WHEN YOU DO WORK IN A FUEL TANK.
_______
(1)
You must obey the fuel safety procedures (Ref. TASK 28-10-00-910-001) when you do work in a fuel tank.
(2)
Put the safety barriers in position.
(3)
Put a warning notice in position to tell persons not to operate the landing gear doors.
1EFF : ALL 1 28-12-41Page 612 1 1 May 01/04R 1 1 1CES 1
Subtask 28-12-41-860-055
B. Aircraft Maintenance Configuration
(1)
Defuel the applicable fuel tanks (Ref. TASK 28-25-00-650-001).
(2)
Drain the remaining fuel from the applicable fuel tanks (Ref. TASK 28-25-00-650-003).
Subtask 28-12-41-010-052
C. Get Access WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE LANDING GEAR DOORS ARE
_______
CLEAR.
(1)
Open the LH MLG door (Ref. TASK 32-12-00-010-001).
(2)
Make sure that the GROUND LOCK SLEEVE (460005835) is installed on the LH MLG door actuator.
(3)
Put the access platform below the zone 147.
(4)
Remove the access panel 147AZ (Ref. TASK 57-17-11-000-001).
(5)
Put the access platform below the zone 540.
(6)
Remove the access panel 540AB (Ref. TASK 28-10-00-910-002), (Ref. TASK 57-27-11-000-001).
(7)
Open the surge door 540BZ.
(8)
Install the HOOK-COVER (RIB2-SURGE DOORS) (98D57004014000) to hold the surge door open.
1EFF : ALL 1 28-12-41Page 613 1 1 May 01/04R 1 1 1CES 1
4. Procedure
_________
(Ref. Fig. 602/TASK 28-12-41-991-002) Subtask 28-12-41-210-051
A. Inspection of the Overpressure Protector 96QM CAUTION : DO NOT APPLY PRESSURE TO THE SAFETY DISC BECAUSE IT WILL EASILY
_______
BREAK.
(1) Examine the overpressure protector (4) to make sure that:
-
there is no damage to the wire mesh (2)
-
there is no damage to the safety disc (3)
-
there is no corrosion
-the sealant on and around the nuts (1) and the head of the bolts
(5) is in the correct condition
-there is no damage to the wire mesh basket (6).
5. Close-up
________ Subtask 28-12-41-410-051
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the HOOK-COVER (RIB2-SURGE DOORS) and carefully close the surge door 540BZ.
(3)
Install the access panel 540AB (Ref. TASK 28-10-00-910-002), (Ref. TASK 57-27-11-400-001).
(4) Install the access panel 147AZ (Ref. TASK 57-17-11-400-001). Subtask 28-12-41-650-054
B. Fuel Configuration
(1) Refuel, defuel or transfer fuel as necessary (Ref. TASK 12-11-28-650-003), (Ref. TASK 28-25-00-650-001) or (Ref. TASK 28-25-00-869-001).
1EFF : ALL 1 28-12-41Page 614 1 1 May 01/04 1 1 1CES 1
Overpressure Protector - Center Tank
Figure 602/TASK 28-12-41-991-002
1EFF : ALL 1 28-12-41 Page 615
1 1 May 01/04
1 1
1CES 1
Subtask 28-12-41-942-051
C. Removal of Equipment
(1)
Remove the safety barriers.
(2)
Remove the warning notice(s).
(3)
Remove the access platform(s).
(4)
Close the LH MLG door (Ref. TASK 32-12-00-410-001).
(5)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 28-12-41Page 616 1 1 May 01/04 1 1 1CES 1 VALVE - FLOAT VENT (15QM,16QM,17QM,18QM,212QM,213QM) - REMOVAL/INSTALLATION
___________________________________________________________________________ R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油2(7)
