曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 of cams in the shock absorber.
 Before the aircraft is towed, the hydraulic system must be depressurized
 through action on a lever which can be locked in its two positions.
 This lever is located on an electrical box easily accessible from the
 ground.
 The maximum towing angle is plus or minus 95 deg.

 1EFF : 401-499, 1 32-51-00Page 7 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Steering System - Principle
 Figure 005

 1EFF : 401-499, 1 32-51-00Page 8 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Wheel Steering Control - Taxi mode
 Figure 006

 1EFF : 401-499, 1 32-51-00Page 9 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Wheel Steering Control - Takeoff/Landing Mode
 Figure 007

 1EFF : 401-499, 1 32-51-00Page 10 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Generation of the Nose Wheel Steering Angle
 Figure 008

 1EFF : 401-499, 1 32-51-00Page 11 1 1 Config-2 Aug 01/05 1 1 1CES 1

 4. Power Supply____________ (Ref. Fig. 009)
 5. Interface_________ (Ref. Fig. 010)
 1EFF : 401-499, 1 32-51-00Page 12 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Steering - Power Supplies Schematic
 Figure 009

 1EFF : 401-499, 1 32-51-00Page 13 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Nose Wheel Steering System - Interface
 Figure 010

 1EFF : 401-499, 1 32-51-00Page 14 1 1 Config-2 Aug 01/05 1 1 1CES 1

 6. Component Description
_____________________
 A. Steering Handwheel Transmitter Unit 1GC (2GC)
 (Ref. Fig. 011, 012)
 There are two steering handwheel transmitters (CAPT and F/O).
 It includes two control potentiometers and two monitoring potentiometers,
 driven by different gears to permit the detection of any rupture of the
 control.
 The travel of each potentiometer is plus or minus 150 deg.
 In addition, it includes a pushbutton switch for the disconnection of the
 steering control through the rudder pedals.

 1EFF : 401-499, 1 32-51-00Page 15 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Nose Wheel Steering - Handwheel Transmitter Unit
 Figure 011

 1EFF : 401-499, 1 32-51-00Page 16 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Nose Wheel Steering - Wiring
 Figure 012

 1EFF : 401-499, 1 32-51-00Page 17 1 1 Config-2 Aug 01/05 1 1 1CES 1 B. Rudder pedals

 Steering orders from the pedals are sent to the BSCU via the ELAC. Steering by pedals is limited to 6 deg. depending on A/C speed.
 1EFF : 401-499, 1 32-51-00Page 18 1 1 Config-2 Aug 01/05 1 1 1CES 1 C. Steering Actuating Cylinders

 The two actuating cylinders operate together to turn the rotating tube of
 the NLG.
 The actuating cylinder drives the rotating tube via a rack-and-pinion
 assembly.
 Two anti-shimmy valves (one per chamber) are installed on the steering
 cylinder.

 -Piston diameter: 79.25 mm
 -Internal stop for plus or minus 95 deg. wheel travel i.e. a stroke of plus or minus 123 mm.
 -Maximum flow: 7.55 l/mn which corresponds to a steering speed of 18 deg./s (at no load)
 1EFF : 401-499, 1 32-51-00Page 19 1 1 Config-2 Aug 01/05 1 1 1CES 1

 D. Selector Valve 7GC (Ref. Fig. 013) The description is the same as the Normal Brake Selector Valve 23GG.
 1EFF : 401-499, 1 32-51-00Page 20 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Selector Valve
 Figure 013
 1EFF :  401-499,  1  32-51-00 Page 21 
1  1  Config-2 Aug 01/05
 1  1
 1CES  1

 

 E. Safety Valve 2900GM
 (Ref. Fig. 014)
 The safety valve is installed between the selector valve and the swivel
 selector valve.
 It stops the flow in the line if there is a leakage.
 The safety valve is made to operate only if the flow is more than or
 equal to 4 l/mn.
 The time for valve closure is less than 5 s (with fluid temperature =
 30deg.C) for a flow rate more than or equal to 5 l/mn under a supply
 pressure of 206 bars (2987 psi).

 1EFF : 401-499, 1 32-51-00Page 22 1 1 Config-2 Aug 01/05 1 1 1CES 1

 Safety Valve
 Figure 014
 1EFF :  401-499,  1  32-51-00 Page 23 
1  1  Config-2 Aug 01/05
 1  1
 1CES  1

 

 F. Hydraulic Block 6GC
 (Ref. Fig. 015)
 A hydraulic block attached to the rear of the nose gear strut includes:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架8(73)