(3)
On the ENG panel 115VU:
-put a warning notice to tell persons not to start the engine 1(2).
(4)
On the HP ground connector:
-put a warning notice to tell persons not to pressurize the pneumatic system.
(5)
On the MAINTENANCE panel 50VU:
-make sure that the ON legend of the ENG/FADEC GND PWR 1(2) pushbutton switch is off
-put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 36-11-00-865-067
C. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AIR BLEED/ENG 1/CTL 3HA1 D12 49VU AIR BLEED/ENG 1/MONG 2HA1 D11 122VU AIR BLEED/ENG 2/CTL 3HA2 Z23 122VU AIR BLEED/ENG 2/MONG 2HA2 Z22
Subtask 36-11-00-010-054
D. Get Access
(1)
Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2)
Put the access platform in position below the engine.
Subtask 36-11-00-040-052
E. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041).
Subtask 36-11-00-010-073
F. Open the left thrust-reverser cowl door (Ref. TASK 78-36-00-010-040): FOR 1000EM1 451AL FOR 1000EM2 461AL
1EFF : ALL 1 36-11-00Page 417 1 1 May 01/05R 1 1 1CES 1
4. Procedure
_________
**ON A/C 001-003, 051-054,
(Ref. Fig. 403/TASK 36-11-00-991-003) R **ON A/C 004-049, 055-099, 101-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 403A/TASK 36-11-00-991-003-A)
**ON A/C ALL
Subtask 36-11-00-040-057
A. Deactivation of the Intermediate Pressure Bleed Check Valve CAUTION : CAREFULLY ALIGN THE LOCKING PIN WITH THE DEACTIVATING HOUSING
_______ ON THE VALVE. IF YOU ALIGN IT INCORRECTLY OR IF YOU TIGHTEN IT TOO MUCH, THE LOCKING PIN CAN REMAIN IN POSITION AND YOU CAN CAUSE DAMAGE TO THE LOCKING PIN THREAD.
(1) On the HP bleed valve (4000HA):
(a)
Use a hexagonal wrench. to set the manual override control to the CLOSED position.
(b)
Remove and discard the lockwire from the locking pin (1).
(c)
Lock the override control (the pressure of the valve is released when you remove the locking pin from its storage port).
1 TORQUE the locking pin (1) to between 0.8 and 0.9 m.daN (70.79
_ and 79.64 lbf.in) if the locking pin head is hexagonal.
2 Manually tighten the locking pin (1) if the locking pin is a
_
knurled knob.
HP Bleed Valve
Figure 403/TASK 36-11-00-991-003
R 1EFF : 001-003, 051-054, 1 36-11-00Page 419 1 1 May 01/05 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
36-11-00Page 420
1 1 May 01/05 1 1 1CES 1
HP Bleed Valve
Figure 403A/TASK 36-11-00-991-003-A
R 1EFF : 004-049, 055-099, 101-149, 151-199, 1 36-11-00Page 421 1201-299, 301-399, 401-499, 1Aug 01/05 1 1 1CES 1
5. Close-up
________ Subtask 36-11-00-410-054
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the left thrust-reverser cowl door (Ref. TASK 78-36-00-410-040): FOR 1000EM1 451AL FOR 1000EM2 461AL
Subtask 36-11-00-440-053
B. Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041). Subtask 36-11-00-410-073
C. Close Access
(1)
Close the fan cowl doors (Ref. TASK 71-13-00-410-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2)
Remove the access platform(s).
(3) Remove the warning notice(s). Subtask 36-11-00-941-065
D. Put a warning notice in the cockpit to tell the crew that the left
(right) HP bleed valve is closed and deactivated.
Subtask 36-11-00-865-068
E. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 2HA1, 2HA2, 3HA1, 3HA2
1EFF : ALL 1 36-11-00Page 422 1 1 Aug 01/03R 1 1 1CES 1
Subtask 36-11-00-869-113
F. Make an entry in the log book. Subtask 36-11-00-862-066
G. De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
1EFF : ALL 1 36-11-00Page 423 1 1 Aug 01/03R 1 1 1CES 1
TASK 36-11-00-440-002
Reactivation of the Intermediate Pressure Bleed Check Valve
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM PNEUMATIC 氣源 1(39)
