R -------------------------------------------------------------------------------R REFERENCE DESIGNATION
R -------------------------------------------------------------------------------
R Material No. CP2244 USA MIL-A-46106A
R primer 1200 (Ref. 70-30-00)
R Material No. CP2497 *
R sealant DC93-006 (Ref. 70-30-00)
R C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
71-13-00-010-040 Opening of the Fan Cowl Doors
71-13-15-991-300 Fig. 401
F 『 EEFF : ALL E Page 40171-13-15
E E Feb 01/00 E E ECES E 3. Job Set-up
F 『
E C F M E
E E
E 56-5B E
E E
__________ Subtask 71-13-15-941-050
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 71-13-15-010-050
B. Get Access
(1) Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
(2) Put a access platform in position.
4. Procedure
_________
(Ref. Fig. 401/TASK 71-13-15-991-300) Subtask 71-13-15-020-050
A. Removal of the Aerodynamic Strake from the Fan Cowl Door NOTE : Removal of the aerodynamic strake from the right or left fan cowl
____
door is the same.
(1) Remove the bolts (5), the washers (20), and the nuts (25) that attach the aerodynamic strake (10) and the back plate (15) to the fan cowl door.
F 『 EEFF : ALL E Page 40271-13-15
E E Feb 01/00 ERE
ECES E F 『 E C F M E E E E 56-5B E
Fan Cowl-Door Aerodynamic-Strake
Figure 401/TASK 71-13-15-991-300
F 『 EEFF : ALL E Page 40371-13-15
E E Feb 01/98 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
(2) Remove the aerodynamic strake (10) and the back plate (15) from the fan cowl door.
R Subtask 71-13-15-914-052
R B. If the strake will not be installed again on the door, seal the strake R fastener holes, as follows:
R (1) Use the DC1200 primer.
R WARNING : DO NOT GET THE DC1200 PRIMER ON YOUR SKIN OR IN YOUR EYES.
_______ R PUT ON PROTECTIVE CLOTHING, GOGGLES AND A FACE MASK. USE R THE PRIMER IN A WELL VENTILATED AREA. IF YOU GET THE PRIMER R ON YOUR SKIN OR IN YOUR EYES, WIPE IT AWAY. GET MEDICAL AID R IF YOUR SKIN OR EYES BECOME IRRITATED.
R (a) Use a brush to apply primer 1200 (Material No. CP2244) on the R strake fastener holes. Apply the primer at least 0.25 in. (6.3499 R mm) more than hole sealant area.
R (2) Permit the primer to dry for a mininmum of 30 minutes.
R (3) Use the sealant.
R WARNING : BEFORE THE USE OF SOLVENT, PROTECTIVE FILM OR SEALANT
_______ R CAREFULLY READ THE APPLICABLE "MATERIAL SAFETY DATA SHEET" R AND FOLLOW ALL LISTED SAFETY AND HEALTH PRECAUTIONS. R USE THESE PRODUCTS IN AN AREA OPENED TO THE AIR AND WEAR R PROTECTION GLOVES. THESE PRODUCTS ARE FLAMMABLE AND VAPOR R IS DANGEROUS. THEY MAY CAUSE IRRITATION OF EYES, NOSE, R THROAT AND SKIN. HIGH CONCENTRATIONS MAY CAUSE WEAKNESS, R HEADACHE, NAUSEA, DIZZINESS AND IMPAIRED JUDGEMENT.
R (a) Mix the sealant DC93-006 (Material No. CP2497), refer to the R manufacturer's instructions.
R (4) Seal the strake fastener holes with the sealant DC93-006 (Material R No. CP2497). The sealant should made a continuous surface on the two R sides of the fan cowl.
R (5) Use a clean cloth to remove any unwanted sealant.
F 『 EEFF : ALL E Page 40471-13-15
E E Feb 01/00 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
TASK 71-13-15-400-001
Installation of the Aerodynamic Strake on the Fan Cowl Door
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 動力裝置 POWER PLANT 1(119)
