(d)
Push and release the down arrow key until the display shows GROUND TESTS?
(e)
Push the YES key on the keypad.
1) Make sure that the display shows SELF TEST?
(f)
Push and release the down arrow key until the display shows PRGM PIN TEST?
(g)
Push the YES key on the keypad.
1) Make sure that the display shows APL type XXX?
NOTE:____The X's are a number. The number is the airplane type. The airplane type is 300/400, or 500.
(h)
Push the YES key on the keypad.
1) Make sure that the display shows these indications: a) CONFIRM APL type b) 737-XXX
(i)
If the airplane type is correct, push the YES key on the keypad. 1) The display will show STORING CONFIG. 2) Make sure that the display shows TEST PASS.
S 745-030
(8) Do the yaw damper coupler self-test:
(a)
Push the ON/OFF key on the keypad. 1) Make sure that the display shows TURN DISPLAY OFF?
(b)
Push the YES key on the keypad. 1) Make sure that the display momentarily shows DISPLAY OFF.
(c)
After 15 seconds, push the ON/OFF key on the keypad. 1) Make sure that the display shows ENTER BITE?
(d)
Push the YES key on the keypad within ten seconds.
1) Make sure that the A/P warning lights on the autoflight status annunciators (P1 and P3) come on.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH 10-62253 YAW DAMPER ú
22-12-01
COUPLER ú
ú 02 ú BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details. Page 503Mar 12/02
A
737-300/400/500MAINTENANCE MANUAL
2) Make sure that the display shows EXISTING FAULTS?
(e)
Push and release the down arrow key until the display shows GROUND TESTS?
(f)
Push the YES key on the keypad. 1) Make sure that the display shows SELF TEST?
(g)
Push the YES key on the keypad.
1) Make sure that the display shows these indications: a) WARNING! WARNING! b) RUDDER MOVEMENT c) RUDDER CLEARED?
(h)
Make sure that all personnel are clear of the rudder.
WARNING:_______THE STEPS THAT FOLLOW CAN CAUSE THE RUDDER TO MOVE. MAKE SURE THAT ALL PERSONS AND EQUIPMENT ARE CLEAR OF THE RUDDER BEFORE YOU DO THESE STEPS. RUDDER MOVEMENT CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
(i)
Push the YES key on the keypad. 1) Make sure that the display shows YD ENGA SW ON?
(j)
Set the yaw damper engage switch on the P5 overhead panel to ON. 1) Make sure that the yaw damper disengage warning light on
the P5 overhead panel goes out.
(k)
Push the YES key on the keypad. 1) Make sure that the display shows TEST IN PROGRESS.
NOTE: During the last seconds of the test, TEST IN
____ PROGRESS will flash on the display. The autoflight status annunciators on the P1 and P3 panels will also flash.
(l)
When the self-test is completed, make sure that the display shows TEST PASS.
(m)
Push the ON/OFF key on the keypad. 1) Make sure that the display shows TURN DISPLAY OFF?
(n)
Push the YES key on the keypad. 1) Make sure that the display momentarily shows DISPLAY OFF.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH 10-62253 YAW DAMPER ú
22-12-01
COUPLER ú
ú 02 ú BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details. Page 504Nov 15/98
A
737-300/400/500MAINTENANCE MANUAL
2) Make sure that the A/P warning lights on the autoflight status annunciators (P1 and P3) go out.
S 865-035
(9) If you will not continue to the yaw damper system test, do these steps:
(a)
Close the Electronic Equipment Access Door, 1201.
(b)
Remove electrical power (AMM 24-22-00/201).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 2(102)
