曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

A 
737-300/400/500MAINTENANCE MANUAL
 S 744-018
 (4) AIRPLANES WITH 10-60447 YAW DAMPER COUPLER;
 Do this task: Yaw Damper Coupler - Adjustment/Test
 (AMM 22-12-31/501).
 S 744-019
 (5) AIRPLANES WITH 10-62253 YAW DAMPER COUPLER;
 Do this task: Yaw Damper Coupler - Adjustment/Test
 ú  (AMM 22-12-32/501).
 ú
 ú  NOTE: If you do not do all of the tests in this task, you can____
 ú  cause nuisance yaw damper system disconnects and nuisance
 ú  faults can possibly be logged in the yaw damper coupler
 ú  memory.
 ú
 D.  Put The Airplane Back To Its Initial Condition
 S 414-016
 (1) Close the Electronic Equipment Access Door (AMM 12-31-11/201).
 S 864-014
 (2) Remove the electrical power if it is not necessary
 (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 22-12-31
 ALL  ú ú 01.1 Page 403 ú Jul 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 YAW DAMPER COUPLER - ADJUSTMENT/TEST
____________________________________
 1.  General_______
 A.  This procedure contains one task. This task makes sure the Yaw Damper Coupler operates correctly.
 TASK 22-12-31-705-010
 2.  Yaw Damper Coupler Test_______________________
 A.  General
 (1)  
Makes sure that you rig the rudder control system correctly.

 (2)  
Make sure all systems that supply data to the yaw damper system work properly.

 B.  References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
AMM 29-15-00/201, Hydraulic Systems A, B, and Standby

 C.  Prepare For The Yaw Damper Coupler Test
 S 865-001
 (1)  Supply the electrical power (AMM 24-22-00/201).
 S 865-017
 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. AILERONS, RUDDER, ELEVATORS, FLAPS, SLATS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (2)  
Supply the hydraulic pressure to the flight control hydraulic system A and B (AMM 29-15-00/201).

 (3)
Make sure the flight control system A and B switches are on.

 S 865-004

 (4)  
Make sure that you close these circuit breakers on the load control center:

 S 865-003
 (a)  P6-2 Circuit Breaker Panel.
 1) MASTER CAUTION BUS

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. AIRPLANES WITH 10-60447 YAW DAMPER ú

 22-12-31
 COUPLER  ú
 ú 02 ú BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.  Page 501Jul 15/98 

A 737-300/400/500MAINTENANCE MANUAL
 2) DIM & TEST
 3) MASTER DIMMING BUS INDICATOR LIGHT
 (b)  P18 Circuit Breaker Panel.
 1) YAW DAMPER AC
 2) YAW DAMPER DC
 3) ENG INTLK

 S 865-009
 (5)  Make sure that you have these conditions for the yaw damper test.
 NOTE: The line voltage must be 115 | 5.8 volts ac and
____
 28 | 1.4 volts dc.

 (a)  
All systems that supply data to the yaw damper are on.

 (b)  
The Autopilot Warning Light comes on steady when you set the Bite test switch to ARM.

 (c)  
The airspeed is at zero knots.

 (d)  
The yaw damper must be engaged.

 NOTE: It is not necessasary to complete these tests in sequence.
____
 S 865-019
 (6)  When the test shows a "repeat" step or when you want to do a specific test, do these steps:
 (a)  
Turn the BITE switch to OFF then to ARM.

 (b)  
Push the GO button until you reach one test before the test you have to do.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 自動飛行 AUTOFLIGHT 2(112)