S 735-019
(4) Do the Interactive Tests - FMA/ADI or FMA/ADI/EFIS (or FMA/EFIS):
(a) Push LSK 1L and make sure that CDU shows the A/T BITE TEST -INTERACTIVE - FMA/ADI or FMA/ADI/EFIS page 1/3 or FMA/EFIS page 1/2.
NOTE: Make sure these circuit breakers are closed when
____ "SET SQUAT TO ON GND" is shown on the CDU:
-LANDING GEAR AIR/GND RELAY & LIGHTS (P6 Panel).
-AFC AFDS MCP DC (P18 Panel).
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
22-31-00
ALL ú ú 04 Page 511 ú Nov 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
(b)
Engage the A/T.
(c)
Push the NEXT PAGE key on the CDU for the FMA/ADI or
FMA/ADI/EFIS page 2/3 or FMA/EFIS page 2/2.
(d)
Push each LSK to make sure the annunciation modes agree with the FMA's (airplanes without EFIS) or the two EADI's or the thrust mode annunciator (airplanes with EFIS).
NOTE: The annunciation indicators will stay on until you push
____
the next LSK.
(e)
AIRPLANES WITH EIS; The A/T LIMIT mode annunciation is on the A/T limit annunciator on the P2-2 Panel.
(f)
AIRPLANES WITHOUT EFIS OR WITH FAST/SLOW DISPLAY ON EADI; Push the NEXT PAGE key and make sure the FMA/ADI page 3/3 or the FMA/ADI/EFIS page 3/3 is shown on the CDU display.
(g)
AIRPLANES WITHOUT EFIS OR WITH THE FAST/SLOW DISPLAY ON EADI; Push each of the LSK in turn.
(h)
Make sure the Fast/Slow pointer and the Fast/Slow flag on each ADI or EADI agrees with the CDU.
(i)
Push LSK 6L (<INDEX) and make sure the CDU goes back to the A/T BITE INTERACTIVE TEST Index page.
S 735-006
(5) Interactive Tests - Input Discretes:
(a) Push LSK 2L (<INPUT DISCRETES) and make sure the CDU shows A/T BITE TEST - INTERACTIVE - INPUT DISCRETES page 1/4 (or 1/6).
NOTE: This page gives general information for the Input
____
discretes tests.
(b)
Push the NEXT PAGE key and make sure the CDU display shows the Input Discretes page 2/4 (or 2/6).
(c)
The four input discretes checks are:
1) PMC 1 - OP/INOP
a) Set the PMC-1 switch on the P5 aft overhead panel to OFF.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
22-31-00
ALL ú ú 04 Page 512 ú Nov 12/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
b) Make sure the CDU shows PMC 1 INOP.
c) Set the PMC-1 switch to ON.
d) Make sure the CDU shows PMC 1 OP.
2) PMC 2 - OP/INOP a) Set the PMC 2 switch on the P5 aft overhead panel to
OFF.
b) Make sure the CDU shows PMC 2 INOP.
c) Set the PMC-2 switch to ON.
d) Make sure the CDU shows PMC 2 OP.
3) GEAR - UP/DOWN
WARNING: MAKE SURE YOU INSTALL THE LANDING GEAR GROUND
_______ LOCK ASSEMBLIES (AMM 32-00-01/201) BEFORE YOU TURN OFF THE LANDING GEAR LEVER AND HYDRAULICS.
CAUTION: NEVER MOVE THE LANDING GEAR LEVER TO "UP"
_______
POSITION FOR THE TESTS.
a) With the landing gear lever down, make sure that CDU
shows GEAR DOWN. b) Pull the landing gear lever out and hold it. c) While the landing gear is down, make sure the CDU shows
GEAR UP. d) Release the landing gear and return it to the normal landing gear down position. 4) SQUAT - IN AIR/ON-GROUND a) Open the LANDING GEAR AIR/GND RELAY & LTS circuit breaker on P6 circuit breaker panel.
NOTE: Make sure the CDU shows SQUAT IN AIR.
____
b) Close the LANDING GEAR AIR/GND RELAY & LTS circuit breaker. c) Make sure the CDU shows SQUAT ON GND.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
