B.  
Standard Tools and Equipment

 (1)  
Hoist - Single Cable Ratchet, 1500-pound
 (680-kg) capacity, with the safety
 hooks, L4H150, Ingersall Rand,
 Shippensberg, PA

 (2)  
Dynamometer - 0-1000 pound (0-500 kg) capacity,
 | 2% accuracy, AP30006-0027,

 W. C. Dillon Co. Inc., Van Nuys, CA (not necessary if the crane includes an adjustable load limiter)

 C.  
References

 (1)
AMM 71-11-04/201, Fan Cowl Panels

 (2)
AMM 71-11-04/401, Fan Cowl Panels

 (3)
IPC 30-21-03 Fig. 8

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-11-01
 ALL  ú ú N01 Page 401 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
(4)  
IPC 71-00-51 Fig. 1

 (5)  
IPC 71-11-01 Fig. 1

 D.
Access

 (1)  
Location Zone
 411 Engine 1 - Inlet Cowl
 421 Engine 2 - Inlet Cowl
 431 Engine 3 - Inlet Cowl
 441 Engine 4 - Inlet Cowl

 E.
Procedure

 S 864-002-N00
 (1)  For the applicable engine, open this circuit breaker and install the DO-NOT-CLOSE tag:
 (a)  P6 Main Power Distribution Panel
 1) 6H19 PROBE HEAT ENG 1
 2) 6H21 PROBE HEAT ENG 2
 3) 6H23 PROBE HEAT ENG 3
 4) 6H25 PROBE HEAT ENG 4

 S 014-003-N00
 (2)  
Open the fan cowl panels (AMM 71-11-04/201) or remove the fan cowl
 panels (AMM 71-11-04/401).

 S 034-004-N00

 (3)  
Disconnect the thermal anti-ice (TAI) duct (4) for the fan case from the inlet cowl (1) (Fig. 401).

 (a)  
Remove the coupling (2) from the end of the TAI duct (4).

 (b)  
Discard the gasket (3).

 CAUTION: INSTALL THE CAPS ON THE OPEN ENDS OF THE FAN CASE AND TAI
_______ DUCT IMMEDIATELY AFTER YOU DISCONNECT THEM. IF YOU DO NOT INSTALL THE CAPS ON THE OPEN ENDS, CONTAMINATION WILL GET INTO THE TAI DUCTS AND CAUSE DAMAGE TO THE ENGINE.
 (c)  Install the cap on the open ends of the TAI duct (1) for the inlet cowl and the TAI duct (4) for the fan case.
 S 034-005-N00
 (4)  Disconnect the PT2/TT2 line (5) from the inlet cowl (4) (Fig. 402).
 (a)  Install the caps on the open ends of the PT2/TT2 line (5).
 S 034-006-N00
 (5)  
Disconnect the electrical connectors (1, 2, and 3) from the inlet
 cowl (4) (Fig. 402).

 (a)  Install the caps on the open ends of the electrical connectors (1, 2, and 3).

 (6)  
Install the inlet cowl sling (Fig. 403).

 S 494-007-N00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-11-01
 ALL  ú ú N01 Page 402 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.

A

MAKE SURE THAT THE LOCKBOLT DOES NOT GO MORE THAN THE TOP OF THE DUCT INTO THE FAN COWL PANEL
Inlet Cowl Thermal Anti-Ice (TAI) Duct Installation Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 71-11-01
 ALL  ú ú N01 Page 403 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////
SEE  SEE A  B  ELECTRICAL CONNECTORS 1. 2. 3.
ELECTRONIC ENGINE CONTROL (EEC) (REF)  4. INLET COWL 

FWD 
4. INLET COWL 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 動力裝置 POWER PLANT 2(61)