Maintenance Practices
1.
General ......................................... 201

2.
Remove/Install the Propeller Governor ................. 201

3.
Remove/Install the Propeller Control Cable ............. 205

4.
Adjust the Propeller Control Cable .................... 210

DA 40 F

CHAPTER 61
PROPELLER
Paragraph 1 is amended to read:
1. General
This Chapter tells you about the propeller installed on the DA 40. Section 61-10 tells you about the % propeller assembly for airplanes with the Lycoming IO-360-M1A engine installed.
)  Section 61-11 tells you about the propeller assembly installed for airplanes with the TAE 125 Diesel engine installed.
%) Section 61-12 tells you about the propeller assembly installed for airplanes with the Lycoming % O-360-A4M engine installed.
)  Section 61-20 tells you about the propeller governor for airplanes with the Lycoming engine installed.
)  Section 61-21 tells you about the propeller governor for airplanes with the TAE 125 Diesel engine installed.
For more data on the propeller refer to the propeller manufacturers' manuals.
Note:  Equipment which is certified for installation in the DA 40 is listed in Section 6.5 of the Airplane Flight Manual. Such equipment may be installed in accordance with the Airplane Maintenance Manual.
Any equipment which is not listed in Section 6.5 of the Airplane Flight Manual is called "Additional Equipment". The installation of Additional Equipment is a modification which must be handled in accordance with national regulations or a Service Bulletin.
Doc # 6.02.01  Page 1a
61-00-00
DA 40 Series AMM
DA 40 F

The caption of figure 1 is amended to read:
% Figure 1: Typical Propeller Assembly for 3-Bladed Constant Speed Propeller
DA 40 Series AMM

Figure 1a is inserted:

Figure 1a: Propeller Assembly for the DA 40 F version with Lycoming O-360-A4M engine
Doc # 6.02.01 Page 3
61-00-00
DA 40 Series AMM
DA 40 F

Intentionally left blank
DA 40 F

Section 61-10 % Propeller Assembly - Lycoming IO-360-M1A Engine
1. General
The first sentence is amended to read:
%  The DA 40 with the Lycoming IO-360-M1A engine installed has an mt-Propeller MTV-12-B/180-17 variable pitch propeller.
Doc # 6.02.01  Page 1a
61-10-00
DA 40 Series AMM
DA 40 F

Intentionally left blank
DA 40 F

Add the new Section 61-12:
Section 61-12
Propeller Assembly - Lycoming O-360-A4M Engine

1. General
The DA 40 F with the Lycoming O-360-A4M engine installed has an Sensenich 76EM8S10-0-63 fixed pitch propeller. This propeller has 2 blades. The blades are made from aluminium. The blades have an acryl lacquer painted finish.
This Section tells you how to remove and install the propeller and how to do a test for blade tracking.
Refer to the propeller manufacturer’s manuals for more data on the propeller.
2. Description
Figure 1 shows you the propeller. The spacer, the rear bulkhead (spinner backplate), the propeller hub and the front bulkhead are attached to the engine flywheel with six special attaching bolts. The bolts are locked with wire. A spinner which is made from composite material attaches to the aft bulkhead with screws. The spinner is supported by the front support (bulkhead) plate. Screws attach the spinner to the front support plate.
3. Operation
The Sensenich 76EM8S10-0-63 is a fixed pitch propeller with 2700 RPM maximum permissible speed. Refer to the manufacturer manual for more details.
Doc # 6.02.01 Page 1
61-12-00
DA 40 Series AMM
DA 40 F

Intentionally left blank
DA 40 F

Trouble-Shooting
1. General
The table below lists the defects you could have for the propeller. If you have the trouble detailed in the Trouble column read across to the Possible Cause column. Then do the repair in the Repair column.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40飛機維護手冊 DA 40 SERIES AMM 6(38)