曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  NOTE : For monitoring and follow up of the play at the rudder trailing____ 
R  edge, it is recommended that the operator record in its own 
R  documentation the values measured. 
R  (1) Connect the SPRING SCALE ASSY (97A27902016000) or GAGE ASSY - PUSH-
R  PULL (97A27003000000) or GAGE ASSY - PUSH-PULL (97A27003000001) to 
R  the LOAD APPLICATION TOOL - ELEVATOR, AILERON, RUDDER 
R  (98D27303000001) and put a force of 30 daN (67.4426 lbf) in the right 
R  direction on the trailing edge. 
R  (2) Continue to apply this force and set the dial indicator to zero. 
R  (3) Release the force. 
R  (4) At the same position, put a force of 30 daN (67.4426 lbf) in the left 
R  direction on the trailing edge. 
R  (5) Continue to apply this force and read the value on the dial 
R  indicator. 
R  (6) Release the force. 
R  (7) Record the trailing edge play related to the Green servo control 
R  pressurized. 
R  Subtask 27-24-00-869-059 
R  B. On the HYD section of the maintenance panel 50VU: 
R  (1) Release the LEAK MEASUREMENT VALVES/G pushbutton switch (the OFF 
R  legend comes on). 
R  (2) Push the LEAK MEASUREMENT VALVES/Y pushbutton switch (the OFF legend 
R  goes off).

 

R  Subtask 27-24-00-220-055 
R  C. Check for too much Play (Yellow servo control pressurized) 
R  NOTE : For monitoring and follow up of the play at the rudder trailing____ 
R  edge, it is recommended that the operator record in its own 
R  documentation the values measured. 
R  (1) At the same position, put a force of 30 daN (67.4426 lbf) in the 
R  right direction on the trailing edge. 
R  (2) Continue to apply this force and set the dial indicator to zero. 
R  (3) Release the force. 
R  (4) At the same position, put a force of 30 daN (67.4426 lbf) in the left 
R  direction on the trailing edge. 
R  (5) Continue to apply this force and read the value on the dial 
R  indicator. 
R  (6) Release the force. 
R  (7) Record the trailing edge play related to the Yellow servo control 
R  pressurized. 
R  Subtask 27-24-00-869-060 
R  D. On the HYD section of the maintenance panel 50VU: 
R  (1) Release the LEAK MEASUREMENT VALVES/Y pushbutton switch 
R  (the OFF legend comes on). 
R  (2) Push the LEAK MEASUREMENT VALVES/B pushbutton switch (the OFF legend 
R  goes off). 
R  Subtask 27-24-00-220-056 
R  E. Check for too much Play (Blue servo control pressurized) 
R  NOTE : For monitoring and follow up of the play at the rudder trailing____ 
R  edge, it is recommended that the operator record in its own 
R  documentation the values measured. 
R  (1) At the same position, put a force of 30 daN (67.4426 lbf) in the 
R  right direction on the trailing edge.

 

R  (2) Continue to apply this force and set the dial indicator to zero. 
R  (3) Release the force. 
R  (4) At the same position, put a force of 30 daN (67.4426 lbf) in the left 
R  direction on the trailing edge. 
R  (5) Continue to apply this force and read the value on the dial 
R  indicator. 
R  (6) Release the force. 
R  (7) Record the trailing edge play related to the Blue servo control 
R  pressurized. 
R  5. Close-up________ 
R  Subtask 27-24-00-080-054 
R  A. Removal of the Tools 
R  (1) Remove the PIN - RIGGING (98D27207546000) (2) or RIGGING PIN SET 
R  (98D27207516000) pin (98D27207516090) from the input lever of the 
R  lower servocontrol (1). 
R  (2) Remove the CHECK TOOL - AILERON, ELEVATOR, RUDDER (98D27303003001) or 
R  CHECK TOOL (ORAP) - AILERON, ELEVATOR, RUDDER (98D27303022000) , the 
R  SPRING SCALE ASSY (97A27902016000) or GAGE ASSY - PUSH-PULL 
R  (97A27003000000) or GAGE ASSY - PUSH-PULL (97A27003000001), and the 
R  LOAD APPLICATION TOOL - ELEVATOR, AILERON, RUDDER (98D27303000001) 
R  from the rudder. 
R  Subtask 27-24-00-942-054 
R  B. Put the aircraft back to its initial configuration 
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱2(130)