Subtask 27-22-00-865-056
 C. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU AUTO FLT/FAC1/28VDC 5CC1 B04
 4. Procedure
_________
 Subtask 27-22-00-440-050

 A. Reactivation of the Channel 1 of the Rudder Trim Actuator
 (1)
 On the panel 187VU, install the relay 7CC1

 (2)
 Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 5CC1.

 Subtask 27-22-00-810-050
 B. Do the trouble shooting of the rudder trim actuator you deactivated (Ref. TSM 22 PB 101).
 5. Close-up
________
 Subtask 27-22-00-410-054

 A. Close Access R (1) Close the access door 824.
 (2) Remove the access platform(s).
 Subtask 27-22-00-862-055

 B. Put the aircraft back to its initial configuration.
 (1)
 Remove the warning notice(s).

 (2)
 De-energize the ground service network
 (Ref. TASK 24-42-00-862-001).

 RUDDER TRIM ACTUATION - ADJUSTMENT/TEST
_______________________________________
 TASK 27-22-00-820-001
 Adjustment of the Rudder Trim Actuation
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS ARE CLEAR.
_______ MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE.
 CAUTION : DO THIS PROCEDURE IN A HANGAR IF THERE ARE WIND GUSTS. WIND GUSTS CAN
_______ CAUSE DAMAGE TO THE LINKAGE WHEN THE RIGGING PINS ARE IN POSITION ON THE RUDDER CONTROL.
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice No specific access platform 5.87 m (19 ft. 3 in.) 6137-013 1 PIN - LOCKING 6137-060 1 PIN - LOCKING 98D27207516000 1 RIGGING PIN SET 98D27207548000 1 PIN - RIGGING 98D27207549000 1 PIN - RIGGING
 1EFF : ALL 1 27-22-00Page 501 1 1 May 01/05R 1 1 1CES 1

 B. Expendable Parts -------------------------------------------------------------------------------
FIG.ITEM --------- |DESIGNATION ------------------------------------ |IPC-CSN----------------------------------
8  cotter pin  27-23-04 02 -080
 8  cotter pin  27-23-04 02A-080
 C. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002  Energize the Aircraft Electrical Circuits from the External Power
 24-41-00-862-002  De-energize the Aircraft Electrical Circuits Supplied from the External Power
 27-22-00-710-002 27-22-51-000-001 27-22-51-400-001 29-10-00-863-003 29-10-00-864-003 29-23-00-863-001 29-23-00-864-001 29-24-00-863-001 29-24-00-864-001  Operational Test of the Rudder Trim ActuationRemoval of the Rudder Trim Actuator (10CC)Installation of the Rudder Trim Actuator (10CC)Pressurize the Blue Hydraulic System with a Ground Power SupplyDepressurize the Blue Hydraulic SystemPressurize the Green Hydraulic System from the Yellow Hydraulic System through the PTU with the Electric PumpDepressurize the Green and Yellow Hydraulic Systems after Operation of the PTUPressurize the Yellow Hydraulic System with the Electric PumpDepressurize the Yellow Hydraulic System
 **ON A/C ALL 

R Post SB 27-1141 For A/C 001-049,051-099,101-105,151-154,157-158,201-207,
 27-22-00-991-001 Fig. 501
 27-22-00-991-002 Fig. 502 **ON A/C ALL

 3. Job Set-up
__________
 Subtask 27-22-00-010-050

 A. Get Access
 (1) Put the access platform in position at the zone 325.
 (2) Open the access doors 325BL, 325BR.
 Subtask 27-22-00-861-053

 B. Energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-861-002).

 Subtask 27-22-00-865-050
 C. Make sure that this(these) circuit breaker(s) is(are) closed:
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FLIGHT CONTROLS 飛行操縱2(73)