曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 S 434-038
 (4)  Connect the switch leads to the terminal block (4). (a) Find equivalent color wires. (b) Connect the stabilizer trim switch and autopilot disengage switch leads at the terminal block (4) (Fig. 401). (c) Install washers (18) and screws (17).
 S 734-024
 (5)  Do a test of the electrical circuit continuity that changed during removal/installation procedures.
 S 734-025
 (6)  Use the insulation tester to do a resistance test on the terminal block while you turn the control wheel from stop to stop. (a) Do a test for resistance to ground, and wire to wire for a minimum insulation value of 100 megohms. 1) Do this test between each wire end terminal and ground and between wire end terminals as follows:
 a)  VIOLET to RED

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-03
 ALL  ú ú 01 Page 409 ú Oct 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 b) VIOLET to ORANGE c) VIOLET to BLACK-ORANGE d) RED to BLACK-ORANGE e) RED to ORANGE f) and BLACK-ORANGE to ORANGE.
 S 434-039
 (7)  
Install these components on the control wheel:

 (a)  
Install the terminal block cover (2) with bolts (20) and washers (19).

 (b)  
Install the sponge rubber pad (3).

 (c)  
Install the medallion (15) with two approach plate screws (16) on the control wheel (1).

 (d)  
Install the medallion (15) to the control wheel (1) with three screws (14).

 (e)  
Align the holes on the brackets.

 (f)  
Install the approach plate (13) on the medallion (15) with washers (11) and nuts (12).

 S 864-014
 (8)  
For the applicable system, remove the DO-NOT-CLOSE tags and close these circuit breakers:

 (a)  
P7 Overhead Circuit Breaker Panel
 1) 7D8 FLT CONT CMPTR PWR L
 2) 7D13 FLT CONT CMPTR PWR C
 3) 7D15 FLT CONT CMPTR PWR R
 4) 7D7 FLT CONT CMPTR SERVO L
 5) 7D12 FLT CONT CMPTR SERVO C
 6) 7D14 FLT CONT CMPTR SERVO R
 7) 7E9 MCP L
 8) 7E18 MCP R
 9) 7E24 AUTO FLT WARN
 10) 7E6 STAB TRIM CONT L
 11) 7E19 STAB TRIM CONT R
 12) 7A20 AUDIO CAPT
 13) 7A21 AUDIO F/O

 

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-03
 ALL  ú ú 01 Page 410 ú Oct 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 414-013
 (9) Install the ceiling access panels.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-03
 ALL  ú ú 01 Page 411 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 AILERON CONTROL DRUM - REMOVAL/INSTALLATION
___________________________________________
 1.  General_______
 A.  There are two tasks in this procedure. There is one task for the removal and one task for the installation of the aileron control drum. The procedure has these parts:
 (1)  
The installation of the door locks on the doors for the main landing gear

 (2)  
The removal of the aileron control drum

 (3)  
The installation of the aileron control drum

 (4)  
The adjustment of the aileron control drum

 (5)  
The operational test of the aileron control drum

 B.  
You can find the aileron control drum below each control column. The aileron control drum supplies a full cable loop to the inboard aileron. If there is a malfunction to the outboard aileron, the operation of the control drum will not change.

 TASK 27-11-04-004-021
 2.  Aileron Control Drum Removal____________________________
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 1(91)