(c)  
Connect the actuator drive to the lockout mechanism crank (9) with the bolt (10) and bushing (11).

 S 434-008
 (2)  
Connect these electrical connectors (7):

 (a)  
DX452 (LH)

 (b)  
DX453 (RH)

 S 864-009
 (3)  
Do this task: "Supply Electrical Power" (Ref 24-22-00/201).

 S 864-010

 (4)  
Remove the DO-NOT-CLOSE tag and close this circuit breaker:

 (a)  
P7 Overhead Circuit Breaker Panel
 1) 7D18 OUTBD AIL LOCKOUT

 S 864-011
 (5) Do this task to pressurize hydraulic systems No. 1 and 4, or 2 and
 3:  "Hydraulic System Pressurization" (Ref 29-11-00/201).
 S 714-012
 (6)  
Use one of the four subsequent procedures to do an operational check of the outboard aileron lockout:

 (a)  
Procedure 1 (Airplanes with two SRMs P/N 285U0015-108 or later)

 1)  Do the existing faults check for the aileron lockout system (Ref 27-11-00/501).

 (b)  
Procedure 2

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-16
 ALL  ú ú 03 Page 404 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 WARNING:_______ MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF THE
 LE AND TE FLAPS AND FLAP DRIVE MECHANISMS BEFORE YOU
 MOVE THE FLAP CONTROL LEVER.  WITH HYDRAULIC POWER
 REMOVED, THE FLAPS WILL MOVE AUTOMATICALLY BY
 ELECTRICAL POWER WHEN YOU MOVE THE FLAP CONTROL
 LEVER.  THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO

 EQUIPMENT.
 1)  Move the flap control lever to the FLAP UP detent to retract the flaps.
 CAUTION: DO NOT INCREASE OR DECREASE THE PITOT STATIC PRESSURE
_______ AT A RATE OF MORE THAN 4 KNOTS EACH SECOND. THIS IS TO PREVENT POSSIBLE DAMAGE TO EQUIPMENT.
 2)  Pressurize the Captain's and the First Officer's pitot static systems to 232 knots maximum (AMM 34-11-00/201).
 NOTE: Use the airspeed indicator on the primary flight
____ display to read the pressure.
 3)  Make sure the lockout actuator stays in the extended position (not locked out).
 CAUTION: DO NOT INCREASE OR DECREASE THE PITOT STATIC PRESSURE
_______ AT A RATE OF MORE THAN 4 KNOTS EACH SECOND. THIS IS TO PREVENT POSSIBLE DAMAGE TO EQUIPMENT.
 4) Increase the pitot static pressure slowly to 245 knots minimum. 5) Make sure the lockout actuator moves to the retracted position (locked out) in 45 seconds.
 NOTE: The 45 second interval is the amount of time used by
____ the SRM monitoring logic to determine if there is a fault with the actuator.
 6)  Turn the control wheels 80 degrees in each direction.
 7)  Make sure the movement of the outboard aileron trailing edge is not more than | 0.50 degree (| 0.40 inch) from the neutral position.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-16
 ALL  ú ú 04 Page 405 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 (c)

A
747-400
MAINTENANCE MANUAL

 CAUTION: DO NOT INCREASE OR DECREASE PITOT STATIC PRESSURE
_______ MORE THAN 4 KNOTS EACH SECOND. THIS IS TO PREVENT POSSIBLE DAMAGE TO THE LOCKOUT MECHANISM.
 8) Decrease the pitot static pressure slowly to 225 knots. 9) Make sure the lockout actuator moves to the extended position (not locked out) in 45 seconds.
 CAUTION: DO NOT INCREASE OR DECREASE PITOT STATIC PRESSURE
_______ MORE THAN 4 KNOTS EACH SECOND. THIS IS TO PREVENT POSSIBLE DAMAGE TO THE LOCKOUT MECHANISM.
 10) Decrease the pitot static pressure to ambient.Procedure 3 1) Move the flap control lever to the FLAP UP detent to
 retract the flaps. 2) Open this circuit breaker and attach a DO-NOT-CLOSE tag: a) P7 Overhead Circuit Breaker Panel
 -7A14 ADC R PWR
 CAUTION: DO NOT INCREASE OR DECREASE PITOT STATIC PRESSURE
_______ MORE THAN 4 KNOTS EACH SECOND. THIS IS TO PREVENT POSSIBLE DAMAGE TO THE LOCKOUT MECHANISM.
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(16)