S 092-081
(2)
Do this task: "Removal of the Door Locks from the Body Landing Gear" (AMM 32-00-30/201).
TASK 32-11-02-202-086
8. Scraper Ring Inspection And Optional Split Scraper Ring Installation for Wing_____________________________________________________________________________ Landing Gear (Fig. 202)____________
A. General
(1)
In several instances, scraper ring damage was found during the installation of the spare seals. In some instances, the scraper ring came through the gland nut. To correct this problem, some operators removed the landing gear from the airplane and disassembled the gear to install new seals and a new scraper ring. This task introduces an optional split scraper ring which can be installed without disassembly of the gear. This procedure also has two quick checks to examine the installed scraper ring while the landing gear is on the airplane.
(2)
The split scraper ring is only a temporary replacement. When you disassemble the gear, replace the split scraper ring with the production scraper ring.
B.
References
(1)
AMM 09-11-00/201, Towing
(2)
AMM 32-00-30/201, Landing Gear Door Locks
C.
Consumable Materials
(1)
D00507 Hydraulic Fluid - MIL-H-6083
D.
Access
(1)
Location Zone
735 Wing Landing Gear, LH
745 Wing Landing Gear, RH
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-11-02
ALL ú ú 01 Page 220 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
E. Prepare for the Procedure
S 492-087
WARNING: YOU MUST CAREFULLY INSTALL THE GROUND LOCKS IN ALL LANDING
_______ GEAR. AN ACCIDENTAL RETRACTION OF THE LANDING GEAR CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
(1) Install the ground locks in all landing gear (AMM 09-11-00/201).
S 492-088
WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASKS BELOW TO INSTALL
_______ THE DOOR LOCKS ON THE LANDING GEAR DOORS. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(2)
Do this task: "Installation of the Door Locks on the Wing Landing Gear" (AMM 32-00-30/201).
S 492-089
(3)
Do this task: "Installation of the Door Locks on the Body Landing Gear" (AMM 32-00-30/201).
F.
Scraper Ring Check
S 222-116
CAUTION: MAKE SURE THAT YOU DO NOT MOVE OR DAMAGE THE WING GEAR TRUCK
_______ SENSORS OR TARGET BRACKET. IF THE TARGET BRACKET OR SENSORS ARE MOVED, THEN THE AIRPLANE SYSTEMS MAY NOT RECOGNIZE AN IN-AIR CONDITION.
(1)
If the sensor or target bracket is moved or damaged, then do the task to measure the wing landing gear truck sensor clearance (AMM 32-61-22/201).
S 212-083
(2)
Check the chrome surface of the inner cylinder before you clean it.
(a)
If there are vertical strips of fluid or particles on the chrome surface, replace the scraper ring.
(3)
Use a mirror and a flashlight to examine the scraper ring.
S 212-084
NOTE: Put the mirror below the outer cylinder and against the inner
____ cylinder to examine the condition of the scraper ring.
(a) If you see damage, replace the scraper ring.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
32-11-02
ALL ú ú 01 Page 221 ú Feb 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
G. Scraper Ring Replacement
S 862-095
(1)
Release the pressure from the shock strut (AMM 32-11-02/801).
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 1(95)
