(e)  
Put a layer of sealant between the shim and the hinge section.

 (f)  
Align fastener holes in the hinge section with the fastener holes in the door and fuselage.

 (g)  
Install the bolts.

 (h)  
Tighten the bolts to the subsequent torques (Fig. 401): 1) Bolt (1) - 290 to 410 pound-inches 2) Bolt (2) - 660 to 780 pound-inches 3) Bolt (3) - 75 to 95 pound-inches 4) Bolt (4) - 35 to 45 pound-inches 5) Bolt (5) - 5/16-24 Bolts 60 to 85 pound-inches

 -
3/8-24 Bolts 95 to 110 pound-inches 6) Bolt (6) - 5/16-24 Bolts 75 to 95 pound-inches

 -
3/8-24 Bolts 35 to 45 pound-inches

 (i)  
Inject the sealant between the hinge sections until the clearances between the hinge sections are full.

 (j)  
Apply a fillet seal of sealant to the top and bottom edges of the hinge section. Make sure the fillet seal touches the injected seal.

 (k)  
Remove the door sling from the side cargo door.

 (3)  
Install the doorway ceiling panel (Ref 25-52-01/401).

 S 414-011
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-32-08
 ALL  ú ú 01 Page 407 ú Oct 10/93
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 414-012
 (4)  Install the rain seal on the cargo door (Ref 52-32-18/401).
 S 864-013
 (5)  Remove the DO-NOT-CLOSE tags and close these circuit breakers for the side cargo door: (a) P415 Power Distribution Center - Right 1) 415F17 SIDE CARGO DOOR CONT (b) P715 Aux/Ext No. 2 Power Center 1) SIDE CARGO DOOR PWR
 S 864-016

 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE AWAY FROM THE DOOR AND
_______ THE DOOR OPENING WHEN YOU OPERATE THE DOOR. FAILURE OF THE LIFT MECHANISM COULD CAUSE THE DOOR TO CLOSE QUICKLY WHICH COULD CAUSE INJURY OR DAMAGE.
 (6) Close the side cargo door (Ref 52-32-00/001)
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-32-08
 ALL  ú ú 01 Page 408 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 LATCH ACTUATOR - REMOVAL/INSTALLATION
_____________________________________
 1.  General_______
 A. This procedure contains two tasks:
 (1)  
The first task is the removal of the latch actuator.

 (2)  
The second task is the installation of the latch actuator.

 TASK 52-32-09-004-001
 2.  Latch Actuator - Removal________________________
 A. References
 (1)  
IPC 52-32-09 Fig. 2

 (2)  
SSM 52-32-01

 (3)  
WDM 52-32-11, 52-32-21

 B.
Access

 (1)  
Location Zone
 261 Main Deck STA 1720 To STA 2040, LH

 (2)  
Access Panels
 836L Door - Main Deck Cargo

 C.
Procedure

 S 414-029
 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE AWAY FROM THE DOOR AND
_______ THE DOOR OPENING WHEN YOU OPERATE THE DOOR. FAILURE OF THE LIFT MECHANISM COULD CAUSE THE DOOR TO CLOSE QUICKLY WHICH COULD CAUSE INJURY OR DAMAGE.
 CAUTION:_______IN CASE THE DOOR DOES NOT OPEN, STOP IMMEDIATELY. DO NOT OPERATE THE DOOR CONTROL SWITCH. HOLDING THE DOOR CONTROL SWITCH MAY DAMAGE THE ACTUATOR. WAIT AT LEAST 1 MINUTE BEFORE SECOND ATTEMPT. IF THE DOOR STILL DOES NOT OPEN, WAIT AT LEAST 10 MINUTES BEFORE THIRD ATTEMPT.
 (1)  
Open the cargo door sufficiently to get access for the rig pin installation.

 S 864-003

 (2)  
Open these circuit breakers for the side cargo door and attach DO-NOT-CLOSE tags:

 (a)  
P415 Power Distribution Center - Right 1) 415F17 SIDE CARGO DOOR CONT

 (b)  
P715 Aux/Ext No. 2 Power Center
 1) SIDE CARGO DOOR PWR

 (3)
Disconnect electrical connector DX213 from the latch actuator.

 S 034-004
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 2(154)