曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 7)  Adjust the switch to make sure there is continuity between
 pins 7 and 8 (aft midspan latch switch) or pins 5 and 6
 (forward midspan latch switch) of connector DX225C as the
 latch actuator (1) is turned 8 |1/4 turns counterclockwise.
 (The switch operates 7 |1/4 turns before the external stops
 contacted [open] position [Fig. 402].)
 NOTE: The switch must operate while the latch actuator is____
 turned to the open stops (counterclockwise).
 One-half turn of the limit switch locknut will
 change the switch operation point approximately one
 turn on the latch actuator.
 8)  Install the lockwire on the switch locknuts.
 9)  Connect electrical connector DX225C to the cargo door
 junction box.

 10) Turn the latch actuator (1) counterclockwise to the fully open position before you operate the door.
 S 864-041
 CAUTION:_______IN CASE THE DOOR DOES NOT OPEN, STOP IMMEDIATELY. DO NOT OPERATE THE DOOR CONTROL SWITCH. HOLDING THE DOOR CONTROL SWITCH MAY DAMAGE THE ACTUATOR. WAIT AT LEAST 1 MINUTE BEFORE SECOND ATTEMPT. IF THE DOOR STILL DOES NOT OPEN, WAIT AT LEAST 10 MINUTES BEFORE THIRD ATTEMPT.
 (22)
 Operate the door electrically until the hook actuators open the door.

 S 214-038

 (23)
 Make sure that all latch cams fully disengage the latch pins before the hooks open the door.

 S 414-039

 (24)
 Close the door and make sure the latch cams engage the latch pins satisfactorily as the hooks close the door.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-32-09
 ALL  ú ú 03 Page 420 ú Jun 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 HOOK ACTUATOR - REMOVAL/INSTALLATION
____________________________________
 1.  General_______
 A. This procedure contains two tasks:
 (1)  
The first task is the removal of the hook actuator from the side cargo.

 (2)  
The second task is the installation of the hook actuator on the side cargo door.

 TASK 52-32-11-004-001
 2.  Hook Actuator - Removal_______________________
 A. References
 (1)  
IPC 52-32-11 Fig. 1

 (2)  
SSM 52-32-01

 (3)  
WDM 52-32-11, 52-32-21

 B.
Access

 (1)  
Location Zone
 261 Main Deck STA 1720 To STA 2040, LH

 (2)  
Access Panels
 836L Door - Main Deck Cargo

 C.
Procedure

 S 864-002
 (1)  
Open these circuit breakers for the side cargo door and attach DO-NOT-CLOSE tags:

 (a)  
P415 Power Distribution Center - Right 1) 415F17 SIDE CARGO DOOR CONT

 (b)  
P715 Aux/Ext No. 2 Power Center
 1) SIDE CARGO DOOR PWR

 

 S 034-004
 (2)  
Disconnect electrical connector DX211 or DX212 from the hook actuator.

 S 024-005

 (3)  
If you will remove the forward hook actuator (1), disconnect the torque tube (5) from the forward output shaft as follows (Fig. 401).

 (a)  
Disconnect the two clamps (6) to remove the torque tube coupling (11).

 (b)  
Pull the torque tube in the forward direction off the actuator output shaft.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 52-32-11
 ALL  ú ú 02 Page 401 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

ELECTRICAL CONNECTOR
FWD
DOOR STRUCTURE
1. FORWARD HOOK ACTUATOR
SEE B
1. AFT HOOK
HOOK-CLOSED

ACTUATOR
SWITCH

SEE A
SEE C HOOK-OPEN
SWITCH

1. ACTUATOR
SEE D
2.
 BOLT

SUPPORT
3.
 WASHER

BRACKET
4.
 NUT (4 LOCATIONS)

5.
 TORQUE TUBE

AFT HOOK ACTUATOR
　
中國航空網 www.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 艙門 DOORS 2(162)